Alpine CDE-7870, CDM-7874, CDE-7872 owner manual Installation, 19-EN

Installation

1	Mounting Sleeve
	(Included)

Dashboard

No Pressure Here

No Pressure Here

CDM-7874/CDE-7872/CDE-7870

Remove the Detachable Front Panel (refer to page 4). Slide mounting sleeve from main unit. (see “Removal” on this page).

Slide the mounting sleeve into the dashboard.

NOTE

Please examine the installation. Make certain that no external pressure is applied to either the top of the unit or the removable nosepiece.

2	Screw
Hex Nut (M5)
	∗∗
	Bolt Stud
Metal
Mounting	∗
Strap

CDM-7874/CDE-7872/

Ground LeadCDE-7870

Chassis

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle’s chassis.

NOTE

For the screw marked **, use an appropriate screw for the chosen mounting location.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDM-7874/CDE-7872/CDE- 7870. Connect all other leads of the CDM-7874/ CDE-7872/CDE-7870 according to details described in the CONNECTlONS section.

3

Lock Pin

Slide the CDM-7874/CDE-7872/CDE-7870 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Removal

1Remove the DETACHABLE FRONT PANEL.

2Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Face Plate

Screws (M5 ⋅ 8)

(Included)

CDM-7874/CDE-7872/CDE-7870

Ground Lead

∗

Mounting Bracket

NOTE

Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis.

19-EN