Canon Restoring Factory Default Settings on Security Cameras using liveapplet

Note

Restoring the Factory Default Settings

If you click the “OK” button at this point, it will not possible to abort the process to

restore the default settings. Click the “Cancel” button if you do not wish to restore the

default settings.

4.The VB-C10/VB-C10R’s factory default settings are restored.

Settings other than network-related settings such as the VB-C10/VB-C10R’s IP address, subnet mask, and default gateway address are returned to factory default settings.

If the IP Address and Password are Unknown

If the VB-C10/VB-C10R’s IP address or administration password are not known or have been forgotten, the VB-C10/VB-C10R cannot be operated over a network. In this case, press the Reset switch at the bottom of the unit.

1.Hold the Reset switch while you turn the VB-C10/VB-C10R’s power switch off and then on again.

The Reset switch is located toward the rear on the bottom. Use a thin tipped object such as the end of a paper clip to press the Reset switch.

See page 2-4 “Turning the Power ON and OFF” for procedures on how to turn OFF and ON the VB-C10/VB-C10R’s power switch.

2.Hold the Reset switch for more than 5 seconds even after the power switch is turned ON.

All settings in the VB-C10/VB-C10R will be returned to the factory default settings.

Appendix

Note

VB-C10

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

THIS CLASS B DIGITAL APPARATUS MEETS ALL REQUIREMENTS OF THE CANADIAN INTERFERENCE -CAUSING EQUIPMENT REGULATIONS.CET APPAREIL NUMÉRIQUE DELA CLASSE B RESPECTE TOUTES LES EXIGENCES DU RÈGLEMENTSUR LE MATÉRIEL BROUILLEURDU CANADA.

0 1 2 3 4 5 6 7 8 9

CANON INC.

MADE IN JAPAN

RESET

0 0 0 0 8 5 2 2 8 0 0 0

If the Reset switch is pressed and all factory default settings are restored, the VB-C10/

VB-C10R’s network-related settings such as IP address, submask, and default

gateway address are all also returned to the factory default settings, making it impossible to operate the VB-C10/VB-C10R from a PC connected to it. Use “VBIPI.exe” on the supplied CD-ROM to set an IP address appropriate to the environment you will be using (→ P.3-3).

8-5