aSafe Use of Equipment
fig-1
EXAMPLE OF ANTENNA GROUNDING AS
PER NATIONAL ELECTRICAL CODE
| ANTENNA | |
| LEAD IN WIRE | |
GROUNDING | ANTENNA | |
DISCHARGE | ||
CLAMP | UNIT (NEC | |
| SECTION | |
ELECTRIC | GROUNDING | |
CONDUCTORS | ||
SERVICE | ||
(NEC SECTION | ||
EQUIPMENT | ||
| ||
| GROUNDING CLAMPS | |
| POWER SERVICE | |
| GROUNDING ELECTRODE | |
| SYSTEM | |
NEC — NATIONAL ELECTRIC CODE | (NEC ART 250. PART H) |
13.Lightning - For added protection of this equipment during a lightning storm, or when it is left unattended and unused for long periods of time, disconnect it from the wall outlet and disconnect the antenna. This will prevent damage to the equipment due to lightning and
14.Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
15.Overloading - Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
16.Object and Liquid Entry - Never push objects of any kind into this equipment through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Be careful not to spill liquid of any kind onto the equipment.
17.Servicing - Do not attempt to service this equipment yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified personnel.
18.Damage Requiring Service - Disconnect this equipment from the wall outlet and all power sources including batteries, and refer servicing to qualified service personnel under the following conditions.
a.When the
b.If any liquid has been spilled onto, or objects have fallen into, the equipment.
c.If the equipment has been exposed to rain or water.
d.If the equipment does not operate normally even if you follow the operating instructions. Adjust only those controls that are covered by the operation instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the equipment to its normal operation.
e.If the equipment has been dropped or the cabinet has been damaged.
f.When the equipment exhibits a distinct change in performance. This indicates a need for service.
19.Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts that are specified by Canon or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.
20.Safety Check - Upon completion of any service or repairs to this equipment, ask the service technician to perform safety checks to determine that the equipment is in safe operating order.
21.Do not install the equipment in the following locations as this can cause a fire or electric shock:
-Hot locations
-Close to a fire
-Very humid or dusty locations
x
