Moisture plus
When to add the steam
This option will only appear in the display after you have selected 1, 2 or 3 bursts of steam.
Tip: If you have selected more than one burst of steam, the 2nd one should be released at least 10 minutes after starting the programme.
– Manual steam
If you want to inject the bursts of steam manually:
Select "Manual steam".
Then set the minute minder to remind you when to release them.
– Time-controlled steam
If you want to time when to release the bursts of steam:
Select
Set the time for each burst of steam. The oven will then release the steam at the specified times. The time counts down as soon as the programme is started.
Touch the OK sensor.
The prompt to draw in water then appears.
Preparing and starting the water intake process
Fill a suitable container with the required amount of fresh tap water.
Open the door.
Pull the water intake pipe forwards (located below the control panel on the left).
Immerse the end of the water intake pipe in the container with tap water.
Touch the OK sensor.
The water intake process will begin.
The amount of water actually drawn up into the oven may be less than the amount specified as required, leaving a small amount in the container.
The water intake process can be interrupted and restarted at any time by touching OK.
61
