DeLonghi KCP815 How to homogenise, “PULSE” function, Defrost function, Cleaning the appliance

Models: KCP815

1 8
Download 8 pages 56.3 Kb
Page 7
Image 7
How to homogenise

“PULSE” functionDefrost function Be careful not to get burnt when opening the lid and/or removing the container!!

How to homogenise

The appliance allows to homogenise all the foods normally used for weaning: fruit, vegetables, meat, fish, rice, etc. Thanks to the special design of its blades, Baby Meal reduces the amount of air bubbles, which cause colic in babies, in the homogenised food it prepares.

By using the appropriate measuring cup (L) put water and the food one wishes to homogenise in the container (G), then in- sert it in its place on the base of the appliance (H).

Put on the lid (C) and close it by turning it clockwise until it clicks into place (fig. 1).

After having used the “boil function” (see page 17) proceed as per “blender function” for roughly 20 seconds (see page 17). To remove the baby food from the container (G), use the spa- tula (P) supplied.

To remove the container (G) at the end of each function switch off the appliance via the appropriate button and remove the lid (C).

Cleaning the appliance•Wrap the power cable carefully around the base of the mo- tor body. Be careful not to get burnt when opening the lid and/or removing the container!!

“PULSE” function

The “PULSE”function enables better control in short processes. This function can only be activated within the manual cooking and blender functions.

The appliance works until the knob (9) is kept in the “PULSE” (fig. 13) position. The appliance work at the pre-set speed.

Defrost function

The defrost function allows to defrost and heat the previously prepared baby food. If present, remove the multi-function bla- de (M) or the mixing paddle (N) from the container (G); pour water into the container (G) until reaching the level marked by

the STEAM symbol, if present remove the lid and any labels from the jar with the food to be defrosted/heated (At- tention: the jar must be made of glass or heat resistant plastic material suitable for heating food up to 100°C, the maximum dimensions of the jar must not exceed: 60 mm diameter, 90

mmheight). Position the jar on the bottom of the container

(G) and set the Boil function according to the instructions in- dicated in the relative section of this instructions manual. To defrost/heat homogenised food weighing about 80 g set the time on 15/20 minutes, in the event of complete homogenised

gb

baby food (about 200-260 g) set at about 25-30 minutes.

Manual background Once the defrost/heating cycle is complete, extract the jar with oven gloves taking great care as it may be very hot.

Manual background for hygienic and biological reasons never heat foods more than once or for a more than an hour.

Before administering heated food to a baby, always check that it is not too hot (above 37°C).

Cleaning the appliance

Ensure that the plug is disconnected from the power mains and that the switch is in position 0.

Open and remove the lid, then remove the container and the stopper before washing them in tepid and soapy water. Rinse and dry thoroughly.

If needed remove the remains of the ingredients by using the spatula(P) supplied. Do not use abrasive products.

To ease cleaning, always dismantle the blades. Wash eve- rything and dry thoroughly, then reassemble.

Attention the blades are very sharp, so when they are not inserted in the appliance, protect them with the protective casing and store them in a safe place out of children’s re- ach.

To prevent the blades from rusting, straight after each use always clean and dry them thoroughly.

It is recommended not to wash the blades in the dishwa- sher because the presence of salt and moisture may cause rust. Wipe the motor body and power cable with a damp cloth or sponge. Dry thoroughly with a soft cloth.

Wrap the power cable carefully around the base of the mo- tor body.

To simplify the cleaning of the cover, slightly pull or use a thin blunt tool (e.g. the spatula provided) to remove the seal from its housing.

To prevent damages to the seal, insert the tool in the outer edge in correspondence of the support hook (see figure).

Manual backgroundWhen putting the seal back into place, make sure that it fits in all the support hooks

18

Page 7
Image 7
DeLonghi KCP815 technical specifications How to homogenise, “PULSE” function, Defrost function, Cleaning the appliance