DeLonghi KCP815 Boil function, Blender function, Ingredients, Cooking Time, 15min, apples/pears

INGREDIENTS	COOKING TIME
FRUIT	15min
apples/pears
MEAT	25min
chicken/turkey/rabbit
veal/beef	30min
FISH
hake/cod/	25/30min
sole/tuna
HARD-BOILED EGGS
1 egg	15min
4 egg	20min
VEGETABLES (100 g)
spinach/chard/tomato	15min
courgettes	20min
fennels/peas	25min
potatoes/carrots/green
beans/pumpkin	30min
cauliflower

Boil function

The boil function allows to boil food.

This function is ideal for preparing homogenised foods.

•After having put water and the food one wishes to boil in the container (G), position it in its place on the base of the applian- ce (H), then put on the lid (C) and close it by turning it clockwi- se until it clicks into place (fig. 1).

•Press the I/0 main switch (I).

•Press the boil button (4) (fig.11). By default the display shows 0:00. To set the desired time press the +/- buttons (5-6) (fig. 11). If one does not wish to set the boiling time the display shows the incremental time. Maximum 30 minutes.

•Press the “START/STOP” (8) (fig. 11) button to start boiling.

The numbers on the display flash until boiling point is reached

(approximately 100°C).

Upon reaching 100°C an acoustic signal is emitted. The countdown time or incremental time starts on the display.

The elapsed set time is signalled by the message on the display and by an acoustic signal. When cooking is complete, if you wish to homogenise the food see the relative chapter.

gb

To remove the container (G) at the end of each function switch off the appliance via the appropriate button and remove the lid (C).

Be careful not to get burnt when opening the lid and/or removing the container!!

In the event there is no water or it runs out, the applian- ce stops working and emits an acoustic signal. The display

shows and the red warning light switches on.

Blender function

Never operate the Pulse function or select a blade rotation speed higher than 3 if the stopper (A) is removed or not inserted properly in the loading ope- ning (D) of the lid (C) as food could spill and if hot cause burns.

The blender function allows to mince and chop up both raw and boiled food.

Proceed as follows:

•After having inserted the blades and food one wishes to blend in the container, position it in its place on the base of the appliance then put on the lid (C) and close it by turning it until it clicks into place.

•Press the I/0 main switch (I).

•Press the “START/STOP” button (8) (fig. 12).

If one wishes to set the operation time (max. 2 min.), use the +/- buttons (5-6) until the desired time is shown on the di- splay. To start processing food simply rotate the knob (9) until selecting the desired speed (4 min. speeds - 8 max. speeds).

Once the set time has elapsed the blades stop, the message appears on the display and the appliance emits an acoustic signal. If one does not wish to set the blending time the display shows the incremental time (maximum 2 minutes). One can however interrupt operation at any time by turning the knob onto 0. The appliance stays in stand-by, press and hold the START/STOP button for 2 seconds to reset the function.

It is not recommended to use this appliance to mince particularly hard food such as frozen food as the blades may get damaged irreparably.

To remove the container (G) at the end of each function switch off the appliance via the appropriate button and remove the lid (C).

17