Be careful not to get burnt when opening the lid and/or removing the container!!

In the event there is no water or it runs out, the applian- ce stops working and emits an acoustic signal. The display

shows and the red warning light switches on.

“CREAM” function

This function is for preparing: custard, pudding, white sauce, etc. It is recommended to apply the mixing paddle (N).

Set the cooking time according to the recipe by operating the “+ and -” buttons.

If one does not wish to set the cooking time the display shows the incremental time (maximum 30 minutes).

Press the start/stop (8) button to start the function. Place the knob (9) in the slow mixing position (1-3) (fig.4).

The end of cooking is signalled via the message on the display and by an acoustic signal.

To remove the container (G) at the end of each function switch off the appliance via the appropriate button and remove the lid (C).

Be careful not to get burnt when opening the lid and/or removing the container!!

In the event there is no water or it runs out, the applian- ce stops working and emits an acoustic signal. The display

shows and the red warning light switches on.

Nota Bene

By placing the knob on position “0”, the blades stop.

If the “START/STOP” (8) button is not pressed within 2 mi- nutes from the setting, the appliance goes into stand-by.

The appliance is equipped with a stopper housing hole (D), useful for pouring a few drops of flavouring/essence or sea- soning without opening the lid.

gb

Steam Cooking Function

The steam cooking function allows to cook food, preserving the proteins and vitamins contained.

Proceed as follows:

Pour water into the container (G) until reaching the steam level marked inside the same container (fig. 8) and insert it in its place.

Insert the steam cooking basket (F) (fig. 9) into the contai- ner with the food to be cooked.

Put on the lid and close it by turning it clockwise until it clicks into place (fig. 1).

Press the I/0 main switch (I).

Press the steam button (3). By default the display shows 0:00.

If one wishes to set the cooking time press the “+ and -” but- tons.

If one does not wish to set the cooking time the display shows the incremental time (maximum 30 minutes).

Press the “START/STOP” (8) button to start steam cooking

(fig. 10).

The numbers on the display flash until boiling point is reached (approximately 100°C). Upon reaching 100°C an acoustic signal is emitted.

The countdown time or incremental time starts on the di- splay.

The elapsed set time is signalled by the message on the display and by an acoustic signal. The steam cooking process is complete.

To remove the container (G) at the end of each function switch off the appliance via the appropriate button and remove the lid (C).

Be careful not to get burnt when opening the lid and/or removing the container!!

In the event there is no water or it runs out, the appliance stops working and emits an acoustic signal.

The display shows and the red warning light switches on.

16

Page 5
Image 5
DeLonghi KCP815 technical specifications Steam Cooking Function, Cream function, Proceed as follows