Cleaning and care
At the end of the activation phase the steam injection system will need to be cleaned to remove all traces of descaling solution.
Cleaning is carried out by flushing approx. 1 litre of fresh tap water through the system. The water is collected in the universal tray. This process is repeated three times.
A message will appear in the display with advice about the rinsing process.
Take the universal tray out of the oven and empty it. Place the tray back in the oven again on the top shelf level.
Detach the plastic tube from the container.
Rinse the container and fill with approx. 1 litre of fresh tap water.
Place the container back in the oven, insert the plastic tube, secure it to the container and close the door.
Touch the OK sensor.
The intake process for the first rinse starts.
Water will be flushed through the steam injection system and will then collect in the universal tray.
A message will appear in the display with advice about the second rinsing process.
Take the universal tray out of the oven and empty it. Place the tray back in the oven again on the top shelf level.
Remove the plastic tube from the container. Rinse the container and fill it with approx. 1 litre fresh tap water.
Place the container back in the oven, insert the plastic tube, secure it to the container and close the door.
!Touch the OK sensor.
"Do the same for the third rinsing process.
Leave the universal tray (with the water which has collected in it during the third rinsing process) on the top oven shelf whilst the evaporation process takes place.
#Remove the container and tube from the oven.
