40-EN
DVD Default Settings (SETUP)

Changing the digital output setting

Use the following procedure to set the digital
audio signal output from the DVA-7996.
NOTE
When the settings are changed, the old settings are
overwritten. Make a note of the current settings before
making changes. The settings are not cleared even when
the vehicle’s battery is disconnected.
1In the stop mode, press and hold the SETUP
button for at least 2 seconds.
The setup menu appears on the monitor screen.
NOTE
This operation cannot be performed in the PRE-STOP
mode. When the disc is being played, press the button
twice to set the stop mode.
AUTO
LPCM
2Use the Joystick to select “DIGITAL OUT”, then
press the ENTER button.
3Use the Joystick to make the selection, then
press the ENTER button.
The digital output is switched automatically
according to the type of audio signals being
played.
Be sure to select “AUTO” when you want to
connect a digital audio processor and play Dolby
Digital audio. “AUTO” is selected upon shipment
from the factory.
The audio signals recorded on the disc are
converted into 48 kHz/16 bit (for DVDs) or 44.1
kHz (for video CDs and CDs) linear PCM audio
signals for output.
NOTE
Press the RTN button to return to the previous screen.
4Press and hold the SETUP button for at least 2
seconds.
The set up are stored and the set up mode is
canceled.
ENTER
SETUP
Joystick