Alpine HDA-5460 operating instructions 39-EN, To prevent noise/interference in the audio system

1Amplifier Link Connector

Outputs Amplifier Link control signals. Connect this to a separately sold Amplifier Link-compatible amplifier, using the (also separately sold) Amplifier Link box KCE-510M.

2Antenna Receptacle

3Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power antenna, if applicable.

This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier, or a signal processor, etc.

4Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your amplifier or signal processor.

5Audio Interrupt In Lead (Pink/Black)

6Illumination Lead (Orange) (CDA-9831 only)

This lead may be connected to the vehicle's instrument cluster illumination lead. This will allow the backlighting of the CDA-9831 to dim whenever the vehicle's lights are turned on.

7Switched Power Lead (Ignition) (Red)

Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position.

8Battery Lead (Yellow)

Connect this lead to the positive (+) post of the vehicle's battery.

9Ground Lead (Black)

Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.

!Choke Coil with Fuse Holder

(10A)

"Power Supply Connector

#Right Front (+) Speaker Output Lead (Gray)

$Right Front (–) Speaker Output Lead (Gray/Black)

%Right Rear (–) Speaker Output Lead (Violet/Black)

&Right Rear (+) Speaker Output Lead (Violet)

(Left Rear (+) Speaker Output Lead (Green)

)Left Rear (–) Speaker Output Lead (Green/Black)

~Left Front (–) Speaker Output Lead (White/Black)

+Left Front (+) Speaker Output Lead (White)

,Ai-NET Connector

Connect this to the output or input connector of another device (CD Changer, Equalizer, etc.) equipped with Ai-NET.

You can input TV/video sound by connecting an optional Ai- NET/RCA Interface cable (KCA-121B) to this component.

-Ai-NET Cable (Included with CD Changer)

.Front Output RCA Connectors

RED is right and WHITE is left.

/Rear Output RCA Connectors

RED is right and WHITE is left.

:Subwoofer RCA Connectors

RED is right and WHITE is left.

;RCA Extension Cable (sold separately)

<System Switch

When connecting a processor or divider using Ai-NET, place this switch in the EQ/DIV position. When no device is connected, leave the switch in the NORM position.

Be sure to turn the power off to the unit before changing the switch position.

To prevent noise/interference in the audio system.

•Locate the unit and route the leads at least 10 cm away from the car harness.

•Keep the battery power leads as far away from other leads as possible.

•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.

•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.

•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

39-EN