Alpine MRV-F900 manual Mounting the brackets, Applying the cushion, Mounting the end covers

Mounting the End Covers

•The product’s appearance can be improved by mounting the end covers on the main unit after installation.

•Mount the end covers after installing the main unit.

1Mounting the brackets

1)Use the included machine screws 6 to mount the three included brackets 5 onto the side opposite the terminal surface.

6

	5
	5
5	Fig. 2

NOTE: APPLYING THE DOUBLE FACE TAPE

Perform the procedure below when you want to securely fasten the end cover or when you do not plan on removing the cover once it is mounted.

1)Peel off the paper from one side of the included double face tape 7.

2)Apply one piece of double face tape 7 to the upper surface of the three brackets 5.

3)Peel off the paper from the other side of the double face tape 7.

75

Fig. 3

2 Applying the cushion

1) Peel off the paper from the included cushion 8.

2) Apply the cushion 8 to the rear side of the end cover 9. 9

8

Fig. 4

3 Mounting the end covers

1) Mount the end covers 9 to the brackets 5. Set the bracket 5 vertically from the top side.

NOTE:

To remove the bracket 5, push up vertically from the bottom upwards, in the opposite direction of when the bracket was installed.

5

9

Fig. 5

7-EN