Alpine MRV-F900 Installation

6-EN

Due to the high power output of the MRV-F900, considerable heat is produced when the

amplifier is in operation. For this reason, the amplifier should be mounted in a location which will

allow for free circulation of air, such as inside the trunk. For alternate installation locations,

please contact your authorized Alpine dealer.

1.Using the amplifier as a template, mark the four screw locations.

2.Make sure there are no objects behind the surface that may become damaged during drilling.

3.Drill the screw holes.

4.Position the MRV-F900 over the screw holes, and secure with four self-tapping screws.

NOTE:

To securely connect the ground lead, use an already installed screw on the metal part of the

vehicle (marked (★)). Be sure this is a good ground by checking continuity to the battery (–)

terminal. As much as possible connect all equipment to the same ground point. These proce-

dures will help eliminate noise.

1 Self-Tapping Screws (M4 x 20)

2 Ground Lead

3 Chassis

4 Holes

Installation

★

Fig. 1