Basic Operations

DISP

Switching Display Modes

Viewing the switching display modes

To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1.Push the foot brake to bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2.Keep pushing the foot brake and release the parking brake once then engage it again.

3.While the parking brake is being engaged the second time, release the foot brake.

NOTE

For automatic transmission vehicles, place the transmission lever in the Park position.

The video lock-out system is now disabled. Unless ignition is turned OFF, this mode can be reactivated by simply engaging the parking brake, without performing the entire procedure above (1 through 3).

If the ignition is turned OFF position, you must perform the entire procedure above.

NOTE

Trying to access the switching display modes while driving will display the warning - PICTURE OFF FOR YOUR SAFETY.

1 Press and hold the DISP button for at least 2 seconds. Each press changes the display modes as follows:

MODE 1 MODE 2 MODE 3 MODE 4

(WIDE) (ZOOM) (CINEMA) (NORMAL)

MODE 1 (WIDE)

Stretches the normal image evenly in a horizontal direction so that it is displayed on the entire screen.

MODE 2 (ZOOM)

Stretches the normal image evenly in a horizontal direction so that it is displayed on the entire screen. The stretching ratio increases the closer to the left or right edge of the screen.

6-EN

Page 8
Image 8
Alpine TME-M790 owner manual Switching Display Modes, Viewing the switching display modes, Mode 1 Wide, Mode 2 Zoom