Alpine TME-M790 owner manual Installation, Place of installation

Installation and Connections

Installation 3

Installing the Monitor

• Place of installation

Before determining the position of installation, check that the display will not hamper gear shifting when it is opened and closed in that position.

NOTE

Install at an angle of within 30 degress from the horizontal.

1

Mounting Sleeve	Dashboard	Mounting Bracket
(Included)		(Included)
	TME-M790

Screws(M4x5) (Included)

Lock Pin

Slide the TME-M790 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Supplied Front Frame.

Removal

1Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

2Pull the unit out, keeping it unlocked as you do so.

Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard. Install the supplied bracket to the monitor.

<JAPANESE CAR>

To install using the vehicle's genuine bracket

TME-M790

Ground Lead

2

Hex Nut (M5)

Ground Lead

Chassis

Screw

Metal Mounting Strap

Bolt Stud

TME-M790

Front Frame (Included)

Screws (M4x5)

Mounting Bracket

Reinforce the monitor with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw () already attached to the vehicle’s chassis.

NOTE

For the screw marked , use an appropriate screw for the chosen mounting location.

16-EN