AltiGen comm 705 Setting Up the IP 705 Phone

IP 705 Manual 15

C

HAPTER

2

Setting Up the IP 705 Phone

To set up the IP 705 phone, follow these instructions:

1. Gather network settings information (this information is needed to

configure the IP 705):

• AltiWare server IP address

• IP 705 phone’s IP address

This address is needed if your company does not use Dynamic Host

Configuration Protocol (DHCP), which automatically assigns IP

addresses to devices when they are connected to the network. The

phone’s IP address can be obtained from your system administrator.

2. Connect the IP 705:

a. Connect the phone to the LAN that AltiServ is on.

b. Connect the handset to the handset port.

c. Connect the power plug to the DC port.

Note: If you want to use Power over Ethernet, see “To Use IP 705

in Power over Ethernet Mode” on page 17.

3. Configure startup network settings. (To display the phone’s menu, as

required below, press the Menu button on the phone. Use the/

buttons to scroll the menus and settings in the LCD screen. Press the

Enter button to select a menu item or a setting.)

If you are using DHCP, ensure that DHCP is enabled on the IP 705

phone: Menu > NETWORK > ENABLE DHCP > Yes. (DHCP is

enabled by default.)

If your company does not use DHCP, disable DHCP on the IP 705

phone: Menu > NETWORK > ENABLE DHCP > No. In this case,

configure the following network settings on the IP 705 after setting up

the phone:

• Local IP address

• IP subnet mask

• Gateway IP address

Contents

Main WARNING! NOTICE TRADEMARKS Contents Page NOTE Page Warranty What The Warranty Covers How Long the Warranty Is Effective Whom the Warranty Protects What the Warranty Does Not Cover How to Obtain Service Effect of State Law Sales Outside the U.S.A. Page Page The IP 705 Phone 4IP 705 Manual Page Page Page Hardware Items in the Package Supported Telephony Features 10 IP 705 Manual The IP 705 Phone IP 705 Manual 11 12 IP 705 Manual The IP 705 Phone IP 705 Manual 13 Page Setting Up the IP 705 Phone The Phone Startup Process To Use IP 705 in Power over Ethernet Mode To Remove the PoE Module Miscellaneous Operation Notes Configuring the IP 705 Phone Important: Phone Settings System Settings 20 IP 705 Manual Configuring the IP 705 Phone Network Settings IP 705 Manual 21 For H.323 version of phone firmware only: Registration from the Phones Menu Configuring IP Settings Assigning a Local IP Address Assigning a TFTP Server Updating Phone Firmware Configuring NAT Enabling NAT Setting Ring Tones Distinctive Ringing Support Workgroup Status Display Page User Guide The LCD Screen Workgroup Status Display Basic Phone Operation User Guide IP 705 Manual 29 30 IP 705 Manual User Guide IP 705 Manual 31 32 IP 705 Manual * * Feature Codes AltiServ Feature Codes Dialing an IP Number Directly from the IP 705 Page Appendix A Specifications Troubleshooting Page LCD Messages 38 IP 705 Manual LCD Messages Local Menu Configuration Messages The following messages may be displayed in the LCD when accessing the IP 705 phones menu: Appendix A IP 705 Manual 39 IP Phone Running Messages The following messages may be displayed in the LCD when running the IP 705: LCD Messages 40 IP 705 Manual IP Phone Boot Messages The following messages may be displayed in the LCD when booting the IP 705: Glossary A B D Page L M N O P Q R S T Mail System U V W Page Index A B C D K L M N P