Manuals / Brands / Communications / Telephone / AltiGen comm / Communications / Telephone

AltiGen comm 705 To Use IP 705 in Power over Ethernet Mode

1 56

Download 56 pages, 744.28 Kb

Setting Up the IP 705 Phone

IP 705 Manual 17

—LOADING FW...

—LOADING NOW.

—Boot Done

—INITIALIZING

—Version xxxx.xxxx.xxxx

To Use IP 705 in Power over Ethernet Mode

1. Unplug the power cord.

2. Remove the screw on the PoE Module cover, and remove the cover.

3. Plug in the PoE Module as illustrated below. The side with four pins

in the center faces the right side.

4. Put the PoE module cover back, and tighten the screw.

5. Move the DC/PoE switch to the PoE position.

6. Connect the phone to an AltiGen-certified PoE-enabled switch.

To Remove the PoE Module

1. Remove the screw on the PoE Module cover, and remove the cover.

2. Notice the “feet” on the two tabs located on the lower end of the

cover. Use these feet to lift the PoE module out of the compartment:

Holding the upper end of the cover, slip the cover into either the right

or left side of the module compartment, between the compartment

and the module, until the feet of the two tabs is under the module (the

inside of the cover should be facing toward the module).

3. Pull up to remove the module.

Right

Left

Contents

Main WARNING! NOTICE TRADEMARKS Contents Page NOTE Page Warranty What The Warranty Covers How Long the Warranty Is Effective Whom the Warranty Protects What the Warranty Does Not Cover How to Obtain Service Effect of State Law Sales Outside the U.S.A. Page Page The IP 705 Phone 4IP 705 Manual Page Page Page Hardware Items in the Package Supported Telephony Features 10 IP 705 Manual The IP 705 Phone IP 705 Manual 11 12 IP 705 Manual The IP 705 Phone IP 705 Manual 13 Page Setting Up the IP 705 Phone The Phone Startup Process To Use IP 705 in Power over Ethernet Mode To Remove the PoE Module Miscellaneous Operation Notes Configuring the IP 705 Phone Important: Phone Settings System Settings 20 IP 705 Manual Configuring the IP 705 Phone Network Settings IP 705 Manual 21 For H.323 version of phone firmware only: Registration from the Phones Menu Configuring IP Settings Assigning a Local IP Address Assigning a TFTP Server Updating Phone Firmware Configuring NAT Enabling NAT Setting Ring Tones Distinctive Ringing Support Workgroup Status Display Page User Guide The LCD Screen Workgroup Status Display Basic Phone Operation User Guide IP 705 Manual 29 30 IP 705 Manual User Guide IP 705 Manual 31 32 IP 705 Manual * * Feature Codes AltiServ Feature Codes Dialing an IP Number Directly from the IP 705 Page Appendix A Specifications Troubleshooting Page LCD Messages 38 IP 705 Manual LCD Messages Local Menu Configuration Messages The following messages may be displayed in the LCD when accessing the IP 705 phones menu: Appendix A IP 705 Manual 39 IP Phone Running Messages The following messages may be displayed in the LCD when running the IP 705: LCD Messages 40 IP 705 Manual IP Phone Boot Messages The following messages may be displayed in the LCD when booting the IP 705: Glossary A B D Page L M N O P Q R S T Mail System U V W Page Index A B C D K L M N P