Installation, Operation, Accessories | Altinex DA1322AT specification

DISTRBUTION AMPLIFIERS

INSTALLATION

Step 1. Connect the power cord to the unit and plug it into the power outlet. The power indicator LED on the back panel will light. This indicates that the unit is operational.

Step 2. Connect the video output of the source (computer or other high-resolution source) to the input of the DA1322AT using a high quality coaxial-type cable. If the source offers a VGA-type 15-pin

OPERATION

The settings of the DA1322AT Distribution Amplifier can be adjusted using the Channel dip switches and Sync control switches as described in Section no. 4. There are no other adjustments necessary to operate the unit. The DA1322AT will operate successfully as long as cables are attached properly and other specifications are followed.

ACCESSORIES

HD connector, for instance, Altinex part

#MS8102CA (6' – 15-pin HD male to 5 BNC male) may be used. The active signal indicator on the back panel will light. This indicates that you have an input signal on the input of the distribution amplifier.

Note: You may have to use an interface with your computer to provide for the appropriate signal format type and to provide for the use of a local monitor if called for.

Step 3. Next, connect the output channels of the amplifier to the display devices (i.e. monitors and /or projectors).

Step 4. Verify that the picture quality on all displays is good. If you are not receiving a signal, make sure that the display is compatible with the resolution of the computer graphics card. If the picture quality is less than perfect, check to make sure that all of your connections are solid and that you are using high quality cable.