Altinex DAV0106-V1A2 manual Installing Your Distribution Amplifier, Operation, Termination Switch

DISTRIBUTION AMPLIFIERS

INSTALLING YOUR DISTRIBUTION

AMPLIFIER 6

Step 1. Connect the power cord to the unit and plug it into the power outlet. The power indicator LED on the front panel will light. This indicates that the unit is operational.

Step 2. Connect the video/audio output of the source (TV, VCR, etc.) to the input of the DAV0106-V1A2using high quality cables. The active signal indicator on the back panel will light. This indicates an input signal on the input of the distribution amplifier.

Step 3. Connect the output channels of the amplifier to the display devices, such as monitors or projectors.

Step 4. Verify that the quality of output signals on all displays or speakers is good. If the quality of the output signal is less than perfect, make sure that all connections are solid and high quality cables are used.

CONGRATULATIONS! YOU ARE DONE.

If you experience any problems, please call

1-800-258-4623 or 1-714-990-2300 for

international calls.

OPERATION 7

The DAV0106-V1A2will operate successfully as long as cables are attached properly and other technical specifications are met.

7.1 TERMINATION SWITCH

The termination switch of the video amplifier, when set to the ON position, will provide 75 Ohms of termination to the input. If the termination switch is in the OFF position, the input will be unterminated. Use the OFF position when using the Video Loop to pass the Video input to a local display, for instance. This switch does not affect the termination of any output signal.

The termination switch of the audio amplifier may be set to 600 Ohms on the audio input if it is in the ON position, and high impedance in the OFF position.

6