![ALTINEX POLICIES](/images/new-backgrounds/27572/2757233x1.webp)
MULTITASKER
Cause 2: The card output is turned OFF.
Solution 1: Turn on the card output that is used. See
Solution 2: If there | is still no | sound, | see |
Cause 3. |
|
|
|
Cause 3: Cable | connections | to | the |
destination are incorrect. |
|
Solution: Make sure the cables are connected properly. Also, ensure that the continuity and wiring are good. If there is still no sound present, see Cause 4.
Cause 4: The destination amplifier has a problem.
Solution 1: Make sure that the destination amplifier is powered. If there is still no sound, see Solution 2
Solution 2: Set the volume of the destination amplifier to a reasonable level. If there is still no sound, call ALTINEX at (714)
8.3 SOUND DISTORTION
Cause 1: The source level is above 1V
Solution: Make sure that the source level is below 1
Cause 2: The destination amplifier provides excessive amplification.
Solution 1: Make sure that the source signal level is high enough so that the destination amplifier does not have to provide excessive amplification and thereby distort the signal. If there is still sound distortion, call ALTINEX at (714)
8.4 SOUND LEVEL IS LOW |
|
| |
Cause 1: The | volume | levels | are |
inappropriate. |
|
|
Solution 1: Turn up the source volume. If sound level is still low, see Solution 2.
Solution 2: Turn up the destination amplifier volume. If the sound level is still low, see Cause 2.
Cause 2 Poor signal transmission.
Solution: Check the cables for continuity and make sure that connections are wired properly to verify that there is good signal transmission.
Note: Test the system by removing the
ALTINEX POLICIES | 9 |
9.1 LIMITED WARRANTY/RETURN POLICIES
Please see the ALTINEX website at www.altinex.com for details on warranty and return policies.
9.2CONTACT INFORMATION ALTINEX, Inc.
592 Apollo Street
Brea, CA 92821 USA
TEL: 714
TOLL FREE:
WEB: www.altinex.com
E-MAIL: solutions@altinex.com
16 |