MULTITASKER
CARD CONTROL
Card control commands allow the main functions of the card to be executed over the
13.[…S] – SAVE
This command saves the configuration command being sent in memory. Send the command [ON4C4S] to enable Output 4 and save the setting. After reset or
14.[ON]
This command will enable an output of a single card, or a group of cards.
SINGLE CARD OPERATION
Command Format: [ONmCn]
m = Output no. (m = # from 1 to 4)
Cn = Card ID (n = # from 1 to max slots)
Example:
There is an
1)[ON1C4]: Turns on only Output 1 of C4.
2)[ONC4]: Turns on all outputs of C4.
GROUP OPERATION
This command enables output "m" for each card in group "k".
Command Format: [ONmGk]
m= Output no. (m = # from
[ON1G1]: Turns on Output 1 for each card in G1. See the GROUP commands for a detailed explanation of groups.
PATH OPERATION
This command will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in "P" are not executed immediately. The path for outputs on multiple cards or the same card may be preloaded.
Command Format: [ONmCnP]
m = Output no. (m = # from 1 to 4)
Cn = Card ID (n = slot # from 1 to max slots)
P= Path
Example:
There are two
[ON1C6P]
[ON3C7P]
[SW]
15.[OFF]
This command disables one or all outputs of a single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCn]
m = Output no. (m = # from 1 to 4)
Cn = Card ID (n = # from 1 to max slots)
Example:
C4 has Outputs 1, 2, and 3 turned on. The following commands may be used to turn off the outputs.
1)[OFF1C4]: Turn off Output 1 only.
2)[OFFC4]: Turn off all outputs.
11 |