Altinex MT109-100 manual Rst, Clr, ONm, MUT0, MUT1, 30. …S Save

MULTITASKER™

Example:

There is an MT109-100in slot 4. Send the command [RAMP=16C4] to set the ramp rate to 16 seconds. After this is set, any ramping will occur at a rate of 32 steps in 16 seconds, or

0.50seconds per step. Confirm the setting by sending the command [RAMPC4] and receiving the feedback:

RAMPTIME = 16 SECONDS

23.[RST]

This command stops ramping and maintains the last volume setting.

Command Format: [RSTCnUi]

Cn = Card ID (n = # from 1 to max slots)

Ui = Unit ID (i = # from 0 to 9)

Example:

The card in slot 4 is ramping up from a volume level of 1 to 32. Send the command [RSTC4] and the card will stop ramping the output volume. The last displayed volume setting will remain the current volume level.

24.[CLR]

This command clears the card's settings and returns them to the factory defaults. Input 1 is selected, the output volume is set to 32/32 and all the input levels are set to 32/32.

Command Format: [CLRCnUi]

Cn	= Card ID (n = # from 1 to max slots)
Ui	= Unit ID (i = from 0 to 9)

Example:

Send the command [CLRC4] to reset the MT109-100in slot 4 to its factory defaults.

25.[ONm]

This command is used to select the input to be active on the output connector.

400-0095-005 15

Command Format: [ONmCnUi]

m= Input number (m = # from 1 to 8)

n= Card ID (n = # from 1 to max slots)

i= Unit ID (i = # from 0 to 9) Example:

There is an MT109-100card in slot 4. Send the command [ON3C5] to select Input 3 as the active input. If the output is disabled (muted), it will remain disabled.

26.[ON] Same as the [MUT0] command.

27.[OFF] Same as the [MUT1] command.

28.[MUT0]

This command turns on (enables) the output volume without changing the input port selected and without changing any volume settings.

Command Format: [MUT0CnUi]

Cn	= Card Slot Number
Ui	= Unit ID (i = # from 0 to 9)

Example:

Send the command [MUT0C4] to turn on the output volume for the card in slot 4.

29.[MUT1]

This command turns off (disables) the output volume without changing the input port selected and without changing any volume settings.

Command Format: [MUT1CnUi]

Cn	= Card Slot Number
Ui	= Unit ID (i = # from 0 to 9)

Example:

Send the command [MUT1C4] to turn off the output volume for the card in slot 4.

30.[…S] – Save

This command will save the configuration

command being sent in memory. When sending the command [VLI1A16C4S], after reset or power up, Input 1 on C4 will be restored with an input volume level of 16.

15