
38.[RMG]
This command may be used to delete an entire group, or all groups.
REMOVE ONE GROUP MEMBERS
Remove all the members from the group, effectively deleting the group.
Command Format: [RMGkUi]
Gk = Group number (k = # from
Ui = Unit ID (i = # from
Example:
Group 1 consists of the cards located in slots number 1, 2 and 3. Remove all cards from the group by sending the command [RMG1]. The system will return the following feedback:
G1=EMPTY
REMOVE ALL GROUPS
Remove all the members from every group, effectively deleting all groups.
Command Format: [RMGÜUi]
Ui = Unit ID (i = # from
Example:
Group 1 consists of cards 1 and 2. Group 2 consists of cards 1, 2, 3, 4 and 5. Delete all the groups by sending the command [RMGÜ]. The system will return the following feedback:
39.[RD]
This command reads and then displays the members in each group.
Command Format: [RDGkUi]
Gk = Group number (k = # from
Ui = Unit ID (i = # from
Example:
The cards in slots 1, 2 and 19 are part of group 5. Read the member data for group 5, by sending the command [RDG5]. The system will return feedback as follows:
G1=C1C2C19
The feedback shows G1 (Group 1) and then the cards that make up Group 1. In this case, Group 1 includes C1, C2 and C19.
40.[CLRG]
This command clears the members for a single group or for all groups. The clear command restores the cards to default settings and is the equivalent to sending the [CLR] command to each individual card.
NOTE: Since this command is sending the [CLR] command to its group members, each card will display its own reset message, if any.
Command Format: [CLRGkUi]
Gk = Group ID (k = # from
Ui = Unit ID (i = # from
Example:
1)To clear group 1 of Unit ID 0, send the [CLRG1] command. This command clears the members for the specified group only.
2)To clear all groups of Unit ID 1, send the [CLRGÜU1] command.
41.[CLM]
This command removes the members in a group and leaves the group empty. It is equivalent to sending the [RMGkUi] command without card references.
Command Format: [CLMGkUi]
Gk = Group number (k = # from
Ui = Unit ID (i = # from
18 |
18