SWITCHERS
7.5 MASTER/SLAVE CONTROL (RS-232):
The feedback codes allow multiple MX2226AT Switchers to be connected in a
When the control port of two units are connected as shown below, the slave unit duplicates the actions of the master unit. The slave unit can still be controlled from its front panel or through another
Master MX2226AT | Slave MX2226AT |
Terminal block pin | Terminal block pin |
TX | RX |
GND | GND |
MX2226AT
7.6 LOOP CONTROL
In some applications, it may be necessary to switch a number of computer video sources to a single presentation display, requiring more inputs than are available from an individual switcher.
To create a larger switcher with more input, the output of the previous unit can be looped to another unit. To maintain the completeness and availability of the incoming video signal, no more than 3 units should be looped. Keep in mind that the Looping Configuration will eliminate one usable input for each looped unit. For example, if two
The loop control feature forces all looped units to select input 6 so that the incoming signal will automatically pass through. If input from switcher no. 1 is selected then input no. 6 is automatically selected on switcher no. 2, so that an incoming signal from the output of switcher no. 1 is passed to the output of switcher no. 2.
9
MX2226AT Unit #1 | MX2226AT Unit #2 |
The coaxial cable between looped switchers must be arranged so that Input 6 always accepts the loop output.
FREQUENTLY ASKED QUESTIONS | 8 | ||
|
|
|
|
No | Question | Answer |
|
|
|
|
|
1 | When I press | You must press and hold |
|
| the RESET | the button for approximately | |
| button, the | 2 seconds, until you hear a |
|
| switcher does | short beeping sound until all | |
| not respond. | of the LED lights flash. This | |
| Why? | is designed to avoid |
|
|
| accidental resetting of the |
|
|
| unit just by touching the |
|
|
| key. |
|
2 | When l press | You must press and hold |
|
| the SOUND | the button for approximately | |
| button, the | 2 seconds, until you hear |
|
| switcher | the beeping sound. This is |
|
| doesn’t | done to set the switcher in |
|
| respond. | either BEEP ON or BEEP |
|
9