ACCESSORIES
Step6 Once you have applied power and connected the proper cables on the bottom of the unit, you may raise the unit. To raise the TNP500/502 into position lift the top by pulling upward at the notch in the top plate.
Step 7. To lower the unit, push on the top of the TNP500 until it fits into place.
For more information, please refer to the FAQ
section or the Troubleshooting Guide.
FREQUENTLY ASKED QUESTIONS (FAQ) 9
No: |
| Question | Answer |
|
|
|
|
1 |
| Why are the VGA | Female cables are more |
|
| connectors | reliable. |
|
| female on both |
|
|
| ends of the |
|
|
| cables? |
|
2Why is there a The
|
|
| serial communication. |
3 |
| What happens if | The unit will not stay |
|
| the spring | open. |
|
| breaks? |
|
4 |
| What do I do if | Replace the gas spring. |
|
| the TNP500/502 | Call ALTINEX for service |
|
| won’t stay open? | information. |
5 |
| How much room | The unit is 4.5 inches |
|
| is taken up on | deep maximum below |
|
| the underside of | the table; to this |
|
| the table? | dimension add about 2.5 |
|
|
| inches for cable |
|
|
| clearance. |
6 |
| What if my table | Then the area under the |
|
| is thicker than 3 | table near the |
|
| inches? | TNP500/502 must be |
|
|
| reduced to 3 inches of |
|
|
| thickness. |
7 |
| Are cables | CONSIDER USING |
|
| available for | |
|
| MS8126CA (3FT) OR | |
|
| connecting a | |
|
| MS8156CA (6FT) FOR | |
|
| PC/laptop to the | |
|
| TNP500/502 | VGA CONNECTION. |
|
| available? |
|
8 |
| Does ALTINEX | Anything modified by non- |
|
| honor any | ALTINEX personnel is not |
|
| warranty on field | covered by warranty. |
|
| modifications? |
|
9