Installing Modules
!WARNING
To avoid risk of personal injury, all controls must be in "OFF" position before removing or installing modules.
Installing Coil and Smoothtop Modules
1.Turn all controls to OFF.
2.Hold module with terminals pointing toward rear of cooktop.
3.Place end of module into cooktop well with terminals facing rear of well.
•If module pan from grille or griddle module is in well, remove before installing coil module.
Rear |
Well |
Front |
4.Slide module towards rear of cooktop until module engages. Lower front of module into well.
Removing Coil and Smoothtop Modules
1.Turn all controls to OFF. Make sure module is cool.
2.Using tab on front of module, lift up slightly.
•Do not lift module too high. Lifting module too high can cause damage to terminals.
3.Pull module toward the front of cooktop and carefully lift it out.
Installing Smoke Control Grill™ Module
1.Turn all controls to OFF.
2.Place module pan with terminal opening towards plug.
Rear |
Well |
Terminal |
opening |
Front |
Module pan |
3.Place grease shield into module pan.
•Smoke control grille element will not operate if shield is not in place.
4.Hold grille element with terminals pointing toward rear of cooktop.
•Slide terminals into plug as far as they go.
•Check grille element to make sure it is fully engaged into plug.
5.Place Grille on module pan.
11
