4.Install the 3/16" screw, and leave 1/8" (3.2 mm) to 3/16" (4.7 mm) protruding from the cutout floor.
A
B¹⁄₈" (3.2 mm) (min) ³⁄₁₆" (4.7 mm) (max)
A. 3/16" screw
B. Cutout floor
5.Slide microwave oven partway into cutout opening.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
6.Plug in microwave oven.
7.Make sure microwave oven is centered in the opening, and slide it into place, engaging the 3/16" screw and duct base.
Install Top and Bottom Brackets
1.Align bottom bracket to duct base, and mark 7 mounting holes of bottom bracket, as shown.
30" (76.2 cm)
27" (68.6 cm)
2.Using 7/64" drill, drill pilot holes into the cabinet through holes marked in Step 1.
3.Install bottom bracket to cabinet using seven 9/16" screws.
4.Position Template 2 over cabinet so that its reference holes (A) (for 27" [68.6 cm] installation) or (B) (for 30" [76.2 cm] installation) are over the upper end mounting holes of the bottom bracket, as shown in following illustration. Tape the template in place, then mark through holes (D) for 27"
(68.6 cm) installation, or through holes (C) for 30" (76.2 cm) installation.
W10308503A
SP PN W10308627A
© 2010
All rights reserved.
NOTE: If Template 2 is missing or unusable, measure straight up from upper end holes on bottom bracket, and mark the new holes at 12¹⁵⁄₁₆" (32.9 cm) and 15²¹⁄₃₂" (39.8 cm). Make sure the bottom bracket end holes and the new holes on each side are plumb.
C DD C
TEMPLATE 2
C DD C
12¹⁵⁄₁₆"
(32.9 cm)
15²¹⁄₃₂"
(39.8 cm)
B AA B
5.Using 7/64" drill, drill pilot holes into the cabinet through holes marked in Step 4, then remove template.
6.Position top bracket over pilot holes drilled in Step 5, then secure with four 9/16" screws. (Illustration in this step shows 30" [76.2 cm] installation.)
A |
B |
C |
D |
A. Top bracket | C. Cutout opening |
B. Cabinet | D. Bottom bracket |
Install Trim Kit Frame
1.Position trim kit frame against the top and bottom brackets. Make sure the trim kit frame makes contact with the cabinet.
2.Open microwave oven door, and secure trim kit frame using 4 painted 1/2" screws.
A
B
C
A. Trim kit frame
B. Microwave oven door (open)
C. Painted 1/2" screws (4)
Installation is now complete. Replace any loose items that have been removed from microwave oven cavity.
Save these Installation Instructions for future reference.