
TOOL ASSEMBLY
CHUCK IDENTIFICATION
WARNING!
To reduce the risk of injury, always unplug tool before attach- ing or removing accessories or making adjustments. Use only specifically recommended acces- sories. Others may be hazardous.
Removing and Replacing
MILWAUKEE's exclusive
WARNING!
To reduce the risk of injury, al- ways use a side handle when us- ing this tool. Always brace and hold securely.
Adjusting the Side Handle (Fig. 2) (Cat. No.
Fig. 2
Side handle
Chuck Type Drill Cat. No.
| Keyed |
| |
|
| ||
|
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
|
|
| Double sleeve |
| |
| Keyless |
| |
|
|
| |
|
|
|
|
| Single sleeve |
| |
| Keyless |
| |
|
|
|
|
Installing and Removing Bits
Fig. 1
1.To remove the
2.To replace the
Gearcase
| Detents |
Locking keys | Side handle ring |
|
1.Turn the side handle counterclockwise to loosen.
2.Slide the side handle assembly forward over the chuck and rotate to the de- sired angle.
3.Slide the side handle back to the gearcase and position the locking keys into the detents. The locking keys help prevent the handle from slipping.
NOTE: The side handle ring must clear the chuck.
4.Turn the side handle clockwise to tighten.
NOTE: Always use the side handle for best control.
WARNING!
To reduce the risk of injury, al- ways remove the chuck key from the chuck after each use.
Keyed Chuck (Fig. 3)
These tools are equipped with a chuck tight- ened using a key. Always unplug the tool before installing or removing bits.
1.To open the chuck jaws, place the chuck key in one (1) of the three (3) holes located on the chuck. Turn the key counterclockwise (Fig. 3).
Fig. 3 | Loosen |
|
Tighten
Be sure the bit shank and chuck jaws are clean. Dirt particles may prevent the bit from lining up properly.
2.When using drill bits, insert the bit into the chuck. Center the bit in the chuck jaws and lift it about 1/16" off of the bottom. Tighten the chuck jaws by hand to align the bit.
When using screwdriver bits, insert the bit far enough for the chuck jaws to grip the bit shank. Tighten the chuck jaws by hand to align the bit.
3.To close the chuck jaws, place the chuck key in each of the three holes in the chuck. Turn the chuck key clock- wise (Fig. 3). Tighten securely.
4.To remove the bit, insert the chuck key into one of the holes in the chuck. Turn the chuck key counterclockwise.
WARNING!
To reduce the risk of injury, do not grasp the bit while the chuck is rotating or while the bit is falling from the chuck.
Double Sleeve Keyless
Chuck (Fig. 4, 5, & 6)
These tools are equipped with a hand tight- ening keyless chuck. Always unplug the tool before installing or removing bits.
1.To open the chuck jaws, hold the collar and turn the sleeve counterclockwise (Fig. 4).
Fig. 4
Tighten
Loosen
8 | 9 |