Proper installation is the installer's responsibility! Write the model & serial numbers on the owner's

manual. The model number label is located on the oven front.

UL Listed=For use over electric heat source

models (Wall Ovens)

,UMC5200BAB/BAW/BAS

• JMC5200BAW

• AM C2206 BAB/BAW/BAQ/BAS

To avoid risk of electrical shock, personal injury, or death, disconnect power to wall outlet before begin- ning installation.

Parts, Tools, and Materials

The following parts are supplied with the oven:

Bracket Base

Trim Frame

Bracket Left

Template 1

Bracket Bottom

template 2

Bracket Top

1" Screw

(1

required,

1 extra)

 

1/2" Screw

(14 required,

6 extra)

Tools required to perform installation:

Phillips Screwdriver

Saw (Electric or Hand)

Drill with 7/64" drill bits (Electric or Hand)

Tape Measure

Pencil

Framing Square

,_Level

Shipping Weight

• Approximate shipping weight is ?? Ibs.

Cutout Dimensions

Height

16 3/4"

16 3/4"

Width

25

1/2"

25

1/2"

Depth (min.)

23

3/4"

23

3/4"

-leight

Electric Heat Source Model

To avoid risk of electrical shock, personal injury, or Jeath:

,Before drilling into the wall, note where electrical outlets are and where electrical wire might be concealed behind the wall. YOU COULD GET AN

ELECTRICAL SHOCK if you contact electrical wire with the drill bit.

,Locate and disconnect the power to any electrical circuits that could be affected by installing this oven.

IFYOU DO NOT DISCONNECTTHE POWER,

IYOU COULD GET AN ELECTRICAL SHOCK_

Electrical rating of this oven:

,120VAC@60Hz

13A/1100W

You need a DEDICATED 120 VAC, 60 Hz, 20A, fused electrical supply (located in the cabinet with the microwave as close as possible to the microwave) serving only the microwave.

Check with a qualified electrician if you are not sure whether the oven is properly grounded or if

you do not completely understand the grounding instructions.

Do not use a fuse in the neutral or grounding circuit.

)ersonal ir

,, Save these instructions for the local electrical inspectoris use.

If there is an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a

grounding plug.

,,Place the plug into a properly installed and grounded outlet.

Amana does not recommend use of an extension cord.

Keep the power cord dry and do not pinch or crush it.

Do not, under any circumstances, remove the power supply cord grounding prong!

This appliance MUST be grounded!

Three-prong

(Grounding plug)

Properly polarized

grounding outlet.

could be exposed to excessive microwave en-

Do not expose yourself to excessive microwave energy!

DO NOT try to operate the microwave oven with the door open.

DO NOT tamper with or defeat the safety interlocks.

DO NOT place objects between the microwave oven front face and the door.

DO NOT allow soil or cleaner residue to build up on the flat surfaces around the microwave oven door.

DO NOT operate the microwave oven if it is damaged.

The microwave oven door must close properly to operate safely.

DO NOT USE THE MICROWAVE OVEN:

,,If the door is bent.

,,If the hinges or latches are broken or loose.

If the door seals, sealing surfaces or glass is broken.

DO NOT ATTEMPT TO ADJUST OR REPAIR THE OVEN YOURSELF!

It should be adjusted and repaired by a qualified

technician who can check for microwave leakage after repairing the oven.

)ersonal in

Before you begin installingthe oven, PLACE A PIECE OF THE CARTON OR OTHER HEAVY MATERIAL (a blanket) over the countertop or cooktop to protect it.

Do not use a plastic cover. Failure to protect these

1

2

Page 1
Image 1
Amana UMTK27, UMTK30 owner manual Trim Frame, Tools required to perform installation, Cutout Dimensions