Adjusting Controls

 

Chilled Door Bin Control

Give the refrigerator time to cool down completely before adding food. It is best to wait 24 hours before you put food into the refrigerator. The settings indicated in the previous section should be correct for normal household refrigerator usage. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm.

Rotary Controls: Turn the control right (clockwise) to make the compartment colder. Turn the control left (counterclockwise) to make it less cold. To turn the cooling system off, turn the Refrigerator Control counterclockwise until it reaches the OFF position.

Slide Controls: Slide the control one setting to the right to make the compartment colder. Slide the control one setting to the left to make it less cold.

If you need to adjust temperatures in the refrigerator or freezer, use the settings listed in the chart below as a guide. Wait at least 24 hours between adjustments.

CONDITION/REASON:

ADJUSTMENT:

 

 

REFRIGERATOR too warm

REFRIGERATOR Control

 

one setting higher

 

 

FREEZER too warm/

FREEZER Control

too little ice

one setting higher

 

 

REFRIGERATOR too cold

REFRIGERATOR Control

 

one setting lower

 

 

FREEZER too cold

FREEZER Control

 

one setting lower

ConvertibleDrawer Temperature Control

(on somemodels)

The control can be adjusted to properly chill meats or vegetables. The air inside the pan is cooled to avoid “spot” freezing and can be set to keep meats at the National Livestock and Meat Board recommended storage temperatures of 28° to 32°F (-2° to 0°C). The convertible vegetable/meat drawer control comes preset at the lowest meat setting.

To store meat:

Set the control to one of the three MEAT settings to store meat at its optimal storage temperature.

To store vegetables:

Set the control to VEG to store vegetables at their optimal storage temperatures.

NOTE: If food starts to freeze, move the control to the left (less cold). Remember to wait 24 hours between adjustments.

Crisper Humidity Control

(on somemodels)

You can control the amount of humidity in the moisture-sealed crisper. Adjust the control to any setting between LOW and HIGH.

LOW (open) for best storage of fruits and vegetables with skins. HIGH (closed) for best storage of fresh, leafy vegetables.

Chilled Door Bin

(on somemodels)

Cool air from the freezer is directed to the refrigerator door bin directly beneath the vents.

NOTE: The dairy compartment and can rack are not associated with the Chilled Door Bin feature.

The chilled door bin control is located on the left-hand side of the refrigerator compartment.

A

A. Chilled door bin control

Slide the door chill control to the left to reduce the flow of cold air to the bin and make it less cold.

Slide the door chill control to the right to increase the flow of cold air to the bin and make it colder.

Water and Ice Dispensers

(on somemodels)

Depending on your model, you may have one or more of the following options: the ability to select either crushed or cubed ice, a special light that turns on when you use the dispenser, or a lock option to avoid unintentional dispensing.

NOTES:

The dispensing system will not operate when the freezer door is open.

After connecting the refrigerator to a water source, flush the water system. Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for

5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) for an additional 2 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.

Allow 24 hours for the refrigerator to cool down and chill water.

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

The Water Dispenser

IMPORTANT: Dispense enough water every week to maintain a fresh supply.

To Dispense Water:

1.Press a sturdy glass against the water dispenser lever.

2.Remove the glass to stop dispensing.

The Ice Dispenser

The dispensing system will not operate when the freezer door is open. Ice dispenses from the ice maker storage bin in the freezer when the dispenser lever is pressed.

NOTE: Some models dispense both cubed and crushed ice. Before dispensing ice, select which type of ice you prefer.

For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing crushed ice. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed to cubed, a few ounces of crushed ice will be dispensed along with the first cubes.

6

Page 6
Image 6
Amana W10180388A ConvertibleDrawer Temperature Control, Crisper Humidity Control, Chilled Door Bin, To Dispense Water

W10180386A, W10180388A specifications

The Amana W10180388A and W10180386A are two essential components for modern kitchen appliances, particularly designed for refrigerator models. These replacement parts enhance both functionality and efficiency of the refrigeration system, ensuring that your food storage needs are met with optimal performance.

The W10180388A is primarily a refrigerator water filter, which plays a crucial role in maintaining water quality. Its primary function is to reduce contaminants, including chlorine, lead, and other potentially harmful substances, providing you with clean and great-tasting water. The filter employs advanced filtration technologies that typically include activated carbon and other media, effectively trapping impurities while allowing beneficial minerals to pass through. This helps in preserving the natural flavor of water, making it ideal for drinking, cooking, and even making ice.

On the other hand, the W10180386A is a replacement ice maker assembly, which is essential for households that prioritize having fresh ice readily available. This component features a reliable ice-making mechanism designed to produce clear, delicious ice cubes efficiently. It operates quietly and efficiently, ensuring that you won’t be disturbed while it functions. The ice maker is built with durable materials and engineered for easy installation, allowing homeowners to quickly restore their appliance’s full ice-making capabilities without calling a technician.

Both products embody the commitment to quality that Amana is known for. They are designed for easy installation, often requiring no more than basic tools to replace. The user-friendly nature of these parts makes them accessible to the average homeowner, reducing maintenance costs and prolonging the lifespan of your appliances.

The W10180388A and W10180386A are also compliant with rigorous safety and performance standards, giving you peace of mind when it comes to your family's health. Regularly replacing the water filter helps ensure that contaminants are consistently reduced, while the ice maker's reliability guarantees you won't run out of ice when hosting gatherings.

In summary, the Amana W10180388A and W10180386A reflect the brand's commitment to innovation, quality, and customer satisfaction. These components not only improve the overall functioning of your refrigeration system but also enhance the experience of using your kitchen appliances, making them integral to any modern home.