GB
Drainage
There are four optional outlets for the drainage tube. To change the outlet of the drainage tube the rear panel should be dismounted.
When remounting the rear panel care should be taken to return all the screws and washers to their original location.
Connecting the permanent outlet
•Connect the pipe to an outlet tube with the correct diameter.
Controls
See page 3, fig. 4
ON/OFF (1)
The unit is switched on and off by pressing the ON/OFF button (1). When the unit is on, the fan runs in the set speed.
Humidity (2)
Press the HUMIDITY button (2) repeatedly to choose the desired level of relative humidity in the area. The corresponding control lights (2) will indicate the selected percentage. The yellow CNT control light
(5)indicates that the unit is running continuously, disregarding the relative humidity level in the area.
Ventilator speed (3)
Press the SPEED button (3) to select low or high speed. The corresponding control light (3) will indicate this, Lo=low or Hi=high.
•Push the other end of the tube into a drain, making sure that the tubing cannot be twisted or folded.
•The entire length of the tube must be slightly inclined.
•Ensure that the outlet of the drainage pipe is NOT under the water level in the drain.
NOTE: In very cold weather conditions precautions should be taken to prevent the drainage pipe from freezing.
Digital display (4)
The digital display (4) will show the measured relative humidity in the area.
Compressor (6)
The COMP control light (6) will be on when the compressor is running. An automatic time delay of five minutes before the compressor can
IMPORTANT:
This dehumidifier should not be used in temperatures below 7 °C or above 35 °C.
Defrost Control
The dehumidifier is equipped with an automatic
6
