IDE Channel 2/3 Master
IDE HDD 
Extended IDE Drive SATA devices setup. You can use one of two methods:
Auto | Allows BIOS to automatically detect SATA IDE devices during POST. |
| (Default value) |
None | Select this if no SATA IDE devices are used and the system will skip the |
| automatic detection step and allow for faster system start up. |
Access Mode | Use this to set the access mode for the hard drive. The two options are: |
| Large/Auto(default:Auto) |
Capacity | Capacity of currently installed hard disk. |
Hard drive information should be labeled on the outside drive casing. Enter the appropriate option based on this information.
Cylinder | Number of cylinders |
Head | Number of heads |
Precomp | Write precomp |
Landing Zone | Landing zone |
Sector | Number of sectors |
Drive A
The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.
None
360K, 5.25" 
1.2M, 5.25"
720K, 3.5"
1.44M, 3.5" 
2.88M, 3.5"
Floppy 3 Mode Support (for Japan Area)
Disabled | Normal Floppy Drive. (Default value) |
Drive A | Drive A is 3 mode Floppy Drive. |
Halt on
The category determines whether the computer will stop if an error is detected during power up.
No Errors | The system boot will not stop for any error that may be detected and you |
| will be prompted. |
All Errors | Whenever the BIOS detects a |
All, But Keyboard | The system boot will not stop for a keyboard error; it will stop for all other |
| errors. (Default value) |
All, But Diskette | The system boot will not stop for a disk error; it will stop for all other errors. |
All, But Disk/Key | The system boot will not stop for a keyboard or disk error; it will stop for all |
| other errors. |
English
- 31 - | BIOS Setup |
