AMD HD 2400 manual Installing CrossFire Graphics Cards, Install a second CrossFire grapchics card

38

For an up-to-date listing of CrossFire™ certified motherboards, see

ati.amd.com/products/certification

For an up-to-date listing of certified power supplies, see:

ati.amd.com/certifiedpsu

Installing CrossFire™ Graphics Cards

The following set of instructions assumes that one ATI Radeon™ HD 2400 Series graphics card has already been successfully installed in the primary slot (slot zero), and that the secondary slot (slot one) is empty. If you have not already done so, see the Getting Started Guide that came with the graphics card for installation instructions.

Install a second CrossFire™ grapchics card

1Turn off the computer, monitor, and other peripheral devices.

2Unplug the computer power cord and disconnect all cables from the back of your computer.

Caution! To avoid possible damage to the motherboard, wait approximately 20 seconds after unplugging the power cord before disconnecting a peripheral or removing a component from the motherboard .

3Remove the computer cover.

If necessary, consult your computer’s manual for help in removing the cover.

Warning! Discharge your body’s static electricity by touching the power supply or the metal surface of the computer chassis. Static discharge may damage your system.

4Remove any non-CrossFire™ supported graphics cards from your computer.

Warning! To ensure it is not too hot to handle, wait about 5 minutes before attempting to remove the graphics card.

5Locate the PCIe™ slots on the motherboard. If necessary, remove the metal backplate cover next to the PCIe™ slot from the computer case.