American Audio 19MXR

leftsideofthemixer.Samples4-6arestoredunderCuebuttons1-3locatedontherightsideoftheboard.The

ControllerModeButtonLEDwillblinkwhentheSamplerisactive.

10. MASTER VOLUME LEVEL INDICATORS - ThedualMASTERLEVELLEDindicatorsareusedtodetailthe

masteroutputlevel.Themeterswilldetailtheoutputlevelofboththeleftandrightchannels.

11. CUE MIXING CONTROL - ThisfunctionsallowsyoutomonitortheCuelevelaswellastheProgram(main

output)levelinyourheadphones. AchannelsCueLevelmay onlybemonitoredifthe channelsCUE (4) func-

tionisselected.Toselect achannelscuefunctionpressthe CUE BUTTON (4) thatisdirectlyassociatedwith

thespecificchannelyouwishtomonitor.YoumayusethemixingfunctiontoblendboththeCuelevelandthe

Programlevel together.Youcan varythe outputlevelto eitherhear moreorless ofeither ofthe twolevels.

TurningtheCueMixingknobtotheCUEposition(left)willallowyoutohearmoreoftheCuelevel.Turningthe

knobtothePGM position(right)will allowyoutohearmoreof theProgramlevel(mainoutput).Youmay also

usetheCue MixingControltohear eithertheCue levelortheProgram levelexclusively.Ifthe knobisin the

fullCUEpositionyou willonlyhearthe cuelevel,ifthe knobisinthe fullPGMpositionyou willonlyhearthe

mainoutput.Thisfunctionisespecially usefulwhenmixingwithoutanmonitor.

12. HEADPHONE JACK - Thisjackisusedtoconnectyourheadphonestothemixerallowingyoutomonitor

thecuesource.Useheadphonesonlyratedat8ohmsto32ohms.MostDJheadphonesareratedat16ohm,

thesearehighlyrecommended.AlwaysbesuretheCUE LEVEL VOLUME (6) issettominimumbeforeyouput

theheadphoneson.

13. CHANNEL VOLUME FADER - Thesefadersareusedtocontrol theoutputsignalofanysourceassigned

toitsparticularchannel.However,mastervolumeiscontrolledbythe MASTER VOLUME CONTROL (7).

14. FEATHER FADER PLUS CROSSFADER - Thisfaderisusedtoblendtheoutputsignalsofchannelsone

andtwotogether.Whenthefaderisinthefullleftposition(channel1),theoutputsignalofchannelonewillbe

controlledbythemastervolumelevel.Thesamefundamentalswillapplyforchanneltwo.Slidingthefaderfrom

onepositiontoanotherwillvarytheoutputsignalsofchannelsoneandtworespectively.Whenthecrossfader

issetinthecenterposition,theoutputsignalsofboththechannelsoneandchannelstwowillbeeven.

15. FADER ASSIGN KNOB - Thisknob assigns a channel to the CROSSFADER (14). When a channel is

assignedtotheleftsideoftheCROSSFADER (14) thatchannelsoutputlevelisroutedtoandcontrolledbythe

CROSSFADER (14).SlidingtheCROSSFADER (14)toleftpositionwillsendthevolumeoutputoftheassigned

channel tothe MASTER VOLUME LEVEL (7), sidingtheCROSSFADER (14) torightpositionwillcutthatchan-

nels volume to MASTER VOLUME LEVEL (7). Thereverseistruefortherightchannelfaderassignswitch.When

theassignswitchissettothe“OFF”positionthecrossfaderwillhavenofunction.

16. CROSSFADER CURVE ADJUSTMENT - Thisrotar yknobisusedtocha ngethewaythecrossfaderwill

operate.Thecrossfadercanoperateindifferentmodes,“NORMALCURVE”,“QUICKCURVE”oranyvariation

ofthetwo.(QuickCurveusuallyusedforscratching).

17. CUE, SYNC, PITCH BEND, & PLAY/PAUSE -

CUE 1, 2, & 3 - These buttons will set or trigger hot cue 1, 2, or 3.

DELETING HOT CUE POINTS - If a hot cue point is set, it is indicated by a lit Cue but ton LED. If you wish

to delete a hot cue point, press the Shift button. The shift b utton LED will ash along with the Cue LEDs.

Press the Cue button that contains the hot cue you wish to delete. After, press the Shift but ton again to

disable the soft shift..

PITCH BEND - To perform temporary pitch bends in V irtual DJ, hold the Shift button and Cue 1 to slow the

track. To speed up the track hold the Shift button and press the Cue 3 b utton. To reset the pitch, hold the

Shift button and press Cue 2.

SYNC - Will sync the selected deck to the opposite de ck or master deck/tempo.

CUE - When the deck is playing, pressing this button will return to the 1st cue point. If the deck is

paused, pressing Cue will set a new cue point.

19MXR CONTROLS AND FUNCTIONS cont.