American Audio 19MXR REAR PANEL, 19MXR CONTROLS AND FUNCTIONS cont.

©American Audio® - www.americanaudio.us - 19MXR Instruction Manual Page 12

18. MICROPHONE 1 - Thiscombojackwillacceptastandard1/4plugorXLR3-pinbalancedmaleplug.The

volumeoutputlevel forthis microphonewillbe controlledbyits ownrespectiveMICROPHONE GAIN CON-

TROL (1). Note: We recommend that you use a 500-600ohm micr ophone for the best sound quality.

19. MICROPHONE 2 - Thisjackacceptsastandard1/4plug.Thevolumeoutputlevelforthismicrophonewill

becontrolledbyitsownrespectiveMICROPHONE GAIN CONTRO L (1). Note: We recommend that you use

a 500-6 00ohm microphone for the best sound quality.

20. MICROPHONE 3 - Thisjackacceptsastandard1/4plug.Thismicrophonewillbecontrolledthrough

theChannel4fader.TheChannel4EQwillalsoeffectthemicrophoneoutput.Besuretoipthe SOURCE

SELECTOR SWITCH (3) tothe“MIC3”positiontooperatethismicrophone’sinputsignal. Note: We recom-

mend that you use a 500-60 0ohm microphone for the best sound quality.

21. CHANNEL 1: LINE 1 INPUT JACKS - DO NOT CONNECT TURNTABLES TO THESE JACKS!CDplayers,

TapeDecksandotherlinelevelinstrumentsmaybeconnectedtothesejacks.TheredcoloredRCAjackrep-

resentstherightchannelinputandthewhiterepresentstheleftchannelinput.Inputvolumewillbecontrolled

bychannelone fader. Thechannel SOURCE SELECTOR SWITCH (3) must beinthe “Analog”position,to

monitoranysourceconnectedtothesejacks.

22. CHANNEL 2: INPUTS - Thetypeofinputmustdirectlyreecttheselectedmodeofthe CHANNEL LINE

LEVEL SELECTOR SWITCH (23). CDplayers,TapeDecksandotherlinelevelinstrumentsmaybeconnected

tothese jacks.Thered coloredRCAjack representsthe rightchannelinput andthe whiterepresentsthe

leftchannelinput.Input volumewillbecontrolledby channeltwo fader. Thechannel SOURCE SELECTOR

SWITCH (3) mustbein the“Analog”position, tomonitoranysource connectedtothese jacks.Turntables

equippedwithMMpickupcartridge(AllDJturntableuseMMpick-upcartridges)maybeconnectedtothese

jacksaslongastheCHANNEL LINE LEVEL SELECTOR SWITCH (23)isinthe“PHONO”position.WhenCD

players,TapeDecksandotherlinelevelinstrumentsareconnectedtothesejackstheCHANNEL LINE LEVEL

SELECTOR SWITCH (23) isin the“LINE”position. Neverconnectline levelinstruments (CDplayers,tape

decks,etc.) tothesejacks whenthe CHANNEL LINE LEVEL SELECTOR SWITCH (23)isin the“PHONO”

position, THIS MAY SERIOUSLY DAMAGE YOUR MIXER! Thered colored RCA jack represents the right

channelinputandthewhiterepresentstheleftchannelinput.Thechannel SOURCE SELECTOR SWITCH (3)

mustbeinthe“Analog”position,tomonitoranysourceconnectedtothesejacks.

23. GND (GROUND TERMINAL) - Besureto connectturntableground leadstoeither orbothof thetwo

availablegroundterminals.Thiswillreducethehummingassociatedwithmagneticphonocartridges.

CHANNEL LINE LEVEL SELECTOR SWITCHES - Theseswitchesareusedtochangethevoltageline

levelsofthere respectedPhono /LineRCA inputsjacks.When connectingturntableswith magneticcar-

tridgesto thesejacksbe surethecorresponding switchis inthe“PHONO” position,and whenusingline

REAR PANEL 19MXR CONTROLS AND FUNCTIONS cont.