American Audio CommanderPlus manual Rear Panel

COMMANDER PLUS™		CONTROLS AND FUNCTIONS
REAR PANEL
37	38	39	40	37

FUSE

AC INPUT 115/230V

FUSE 0.5A,F,250V

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS:RISQUE DE CHOC ELECTRIQUE-NE

PAS OUVRIR.

GND

CAUTION:

DISCONNECT SUPPLY CORD

BEFORE CHANGING FUSE.

ATTENTION:

DEBRANCHER AVANT DE

REMPLACER LE FUSIBLE.

CAUTION:

TO REDUCE THE RISK OF FIRE,

REPLACE ONLY WITH THE SAME

TYPE AND RATING OF FUSE.

ATTENTION:

UTILISER UN FUSIBLE DE

RECHANGE DE MEME TYPE.

AMERICAN AUDIO

PREAMP MIXER

MODEL NO. COMMANDER PLUS

AC 115/230V ~ 50/60HZ 20W

RIGHT BALANCED OUTPUT LEFT

L

RECEIVESEND

R

EFFECT

LIGHT CONTROL

ZONE 2 ZONE 1 REC MASTER

OUTPUT

	PLAYER CONTROL
			AUX 3	PHONO 3	AUX 2	PHONO 2	AUX 1	PHONO 1	GND
	B	A
LINE 6	LINE 5	LINE 4	LINE 3	PHONO 3	LINE 2	PHONO 2	LINE 1	PHONO 1	MIC 3
				AUX 3		AUX 2		AUX 1
								L
								R
	CH-4		CH-3		CH-2		CH-1

41 42 43 44 45 46 47 48 49 50 51 52 53

37.GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of the two available ground terminals. This will reduce the humming and popping noises associated with magnetic phono cartridges.

38.LIGHT CONTROL OUTPUT - This jack provides a preset mono audio output signal. There is no way to adjust this level, however this level will directly reflect the output level of the CHANNEL SLIDERS (10). This buffered audio output should only be used with light controllers that can accept an external audio input signal. This is a great feature for Touch Panels and Chase Controllers, allow- ing a light show to synchronize with the sound system automatically.

39.PLAYER CONTROL - These jacks are used to control the “Q-Start” function between the mixer and a compatible American Audio® or American DJ® CD Player. Input the mini plugs included with your CD player from CD player controller into these jacks, input CD 1 into jack 1 and CD 2 into jack 2 and so on. Be sure to only use the mono tip mini plugs included with your CD player to avoid damage to the mixer and/or the CD player.

40.CHANNEL LINE LEVEL SELECTOR SWITCHES - These switches are used to change the volt- age line levels of there respected Phono / Aux RCA inputs jacks. When connecting turntables with magnetic cartridges to these jacks be sure the corresponding switch is in the “PHONO” position, and when using line level input devices be sure this switch is in the “AUX” position. Always be sure main power is shut off before change the position of the Line Level Selector Switch.

41.AC VOLTAGE SELECTOR - This switch is used to change the operating voltage. Operating volt- age can be toggled between 120v/50Hz or 220v/50~60Hz. Be sure the selector is set to the proper voltage for your area before attempting to operate the unit. Always be sure main power is shut off before change the position of the Voltage Selector Switch.

42.FUSE - This housing stores the 0.5 amp GMA protective fuse. Always replace with the exact same type fuse, unless otherwise instructed, by an authorized American Audio® service technician. Replacing with any other type of fuse than that of the recommended fuse will void your unit war- ranty.

©American Audio® - www.americandj.com - Commander Plus™ Instruction Manual Page 15