Flight Moon™ | Controls and Functions |
|
|
Flight Moon™ | Controls and Functions |
|
|
REAR
1
2
3
4
| 9 10 |
FUSE | 8 |
| 7 |
| 6 |
1 2 3 4 5 ON
5
6
7
8
tective fuse and is also used as the main power supply connection. Use only properly grounded IEC power cord. Always replace with the exact same type fuse, unless other wise instructed, by an authorized Ameri- can DJ® service technician.
5.XLR Output Jack - This jack is used to transmit the incoming DMX signal to another DMX fixture, or transmit a Master/Slave signal to the nest Flight Moon™ in the chain. For best results in DMX or Master/Slave mode terminate this jack if it is the last unit in the chain. See “Terminator” on page 12.
6.Flight Moon/C Controller Jack - This jack is for use with the optional FlightMoon/C footswitch controller only. Do not attempt to con- nect an audio signal this jack, this will damage the PC board and void your manufactures warranty!
7 . Power Indicator - This light is used to indicate proper operation.
FRONT
9
10
11 |
12 |
8. Dip Switches - These switches serve two functions. In master |
slave mode these switches are used to assign a specific head |
address. In DMX mode these switches are used to assign a DMX |
address to the unit. In DMX mode each switch corresponds to a |
specific value based on DMX encoding. See page 10 for a detailed |
explanation of DMX encoding. |
9. Mirror - This is a highly reflective surface mirror specifically designed |
to optimize and enhance beam output. Never use glass cleaner that |
contains ammonia to clean the surface of the mirror (such as Windex). |
10. Audio Sensitivity Knob - This adjust audio sensitivity of the |
internal microphone (3). Turning the sensitivity knob in the clockwise |
direction will increase the sensitivity to sound. Turning the knob in |
the counter clockwise direction will decrease the fixture’s sensitivity |
to sound. |
1.Thumb Holders - These two thumb screw holders are designed to secure the front panel when the unit is in use.
2.XLR Input Jack - This jack is used to accept an incoming DMX signal or Master/Slave signal.
3.Microphone - This microphone receives external low frequencies to trigger the unit in
4.Power Inlet/Fuse Holder - This housing stores a 5 amp GMA pro-
11. Lamp Socket Assembly Plate - This plate accesses the lamp |
socket assembly. Lamp Socket Assembly - This assembly holds a |
12. Focusing Adjustments - This thumb screws are used to focus the |
high quality lens. |
©American DJ® - www.americandj.com - Flight Moon™ Instruction Manual Page 5 | ©American DJ® - www.americandj.com - Flight Moon™ Instruction Manual Page 6 |
