American Dryer MAH6700, MDG6700 installation instructions Washer, Stacking Kit Components

STACKING KIT(GAS) INSTALLATION INSTRUCTIONS (MAH6700 washer & MDG6700 dryer only)

Washer

Step8 : Assemble the Rear Brackets to the washer as shown above. Use two(2) Screws-Hex Head(34001382) with washers in each washing machine top cover tang if there are two holes.

Use one(1) Screw-Hex Head(34001382) with washer in each top cover tang if there is one hole.

STOP HERE

Step10 : Assemble the Rear Brackets to the dryer as shown above. Note that four screws must be used to hold the Rear Brackets to the back of the dryer. Use four(4) Screws-phillips Pan Head(6006- 001174) in the back of the dryer cabinet.Extra screws are included in the kit for this.

Note: When Rear Brackets are assembled to the stacked units, attach the Flexing Hose Use Warning Label(35001251). The label must be placed as close as possible to the dryer gas inlet pipe.

Step11 : Before the stacked unit is pushed into the installed position, the Maytag Flexing Gas Connector(34001465) must be installed on the dryer gas inlet pipe. Attach the 90° elbow of the Flexing Gas Connector to the dryer gas inlet pipe using proper gas sealing materials, such as Teflon® tape, etc. Elbow connection must be gas-tight

Step12 : Connect the other end of the Maytag Flexing Gas Connector(34001465) to the house-supply outlet pipe for the dryer, using proper gas sealing materials, such as Teflon® tape,etc. Leak-test both connections

before proceeding further.

Step 13: Stacked Unit is now ready to be installed. Refer to detailed installa- tion instructions packed with products.

W

W lab

STACKING KIT COMPONENTS:

Stacking Support Guides(2)	-34001449	Screws Phillips-Pan Head(8)	-6006-001174
Rear Bracket(2)	-34001463	Washer(4)
Maytag Flexing Gas Connector(1)-34001465		Label Warning(1)	-35001251
Screws-Hex Head(4)	-34001382

Step 9: Lift and position dryer into the position on the washer shown.

Rear Bracket Maytag Flexing Gas Connector

Sh