4 American Dryer Corp. 113604-4
NOTES _____________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
____________________________________________________________________________________________________________________________________
Introduction to Programming _________The keypad along with the digital display are used to setup
the dryer controls.
Entering and Exiting Service Mode
Entering
Coin/Debit Models
Use security key to activate programming mode.
Non-Coin (OPL) Models
To enter the Program Mode you must hold the STOP key and
the UP ARROW key down.
Exiting
The PERM PRESS/ENTER key must be depressed to save
any changes that have been made.
Coin/Debit Models
Return security key back to its normal position.
Non-Coin (OPL) Models
Exit Service Mode by pressing the STOP key.
Important
If the computer in a non-coin (OPL) unit is set to
coin or free, it will be necessary to connect two
orange wires found loose in the wire bundle directly behind
the computer board. Once this is done, the computer will
be automatically entered into the Service Mode.
!
How to use the Keypad
to Program the Controls
Coin/Debit Controllers
The HIGH key is used to increase numbers and scan through
menu locations.
The MEDIUM key will enter program locations and save
changes made.
The LOW key is used to decrease numbers and scan through
menu locations.
To back out of a program location hit the PAUSE key.
Non-Coin (OPL) Controllers
The UP ARROW is used to increase numbers and scan
through menu locations.
The DOWN ARROW is used to decrease numbers and scan
through menu locations.
The START/ENTER key will enter program locations and save
changes made.
To back out of a menu location hit the STOP/PAUSE key.
Caution
The service access panel must not be opened
unless power is first disconnected from the dryer.
Before proceeding it is worth noting that, despite all the
options available, an owner can simply choose to uncrate a
new commercial machine, hook it up, plug it in and have a
unit which operates.
Note
On stacked dryers programming selections apply
to both pockets.
!
!