American Innovative 7000, 7045, 7506, 3545, 3500 installation instructions Wall/Reverse Wall Mount

FLEXmount™ Set-up Options Page 5

Through-Desk Mount

Step 1

Drill a hole 3/8” into desk or mounting surface bout 1 1/2”-2” in from the edge of the surface edge.

Step 2

Remove the backing on the Neoprene foam pad and affix to the bottom of the mount cup. (ONLY if you will not be using the baseplate set-up in the next step)

Step 3

Line up the mount cup over the hole and drop the 2.5” threaded bolt into the mount cup, through the optional base plate and through the desk.

Without	With
Baseplate	Baseplate

Step 4

Under the desk, slide the rectangular spacer onto the 3/8-16 x 2 1/2” Hex Head Bolt. Attach the nut to the bolt and tighten until the mount is secured to the desk.

NOTE: The rounded part

of the nut should be facing downward.

Wall/Reverse Wall Mount	Wall mounting hardware
	is not provided.

Step 1

Secure the large “L” bracket to a stud in the wall using wood screws.

Reverse Wall Mount: Follow Step 1 above; be sure the short side of the “L” bracket is on top.

Mounting
Hardware	Mounting
	Hardware
	Reverse

Step 2

Drop the nylon stop nut into the impres- sion inside the mount cup.

The rounded top of the nylon stop nut should be facing upward.

Step 3

Align the mount cup over the short end of the large “L” bracket so you can screw the two components together using the 3/8-16 x 7/8” Button Head Socket Cap screw and tighten using the 7/32” allen wrench. The mount is secure when the 3/8” screw no longer turns.

If you are using the Reverse Mount configuration, the 3/8-16 x 1 1/4” Flat Socket Cap Screw should be used.

Reverse