American Power Conversion 3U Rack Mount user manual it with the battery pack opening and slide the

REINSTALLING THE BATTERY TRAYS AND ATTACHING THE FRONT BEZEL

			1.		Supporting the battery tray on the bottom, align
					it with the battery pack opening and slide the
					tray into the compartment.
			2.		Replace the two screws to secure the battery
					pack face plate.
			3.		Locate the battery cables Πand the UPS bat-
					tery connector jacks • to the right of each bat-
					tery tray.
				4.	To connect the battery connector plug to the
					battery jack, push the plug into the jack so the
Œ	•	Œ	•
					metal pieces inside each part are touching.
					Press firmly to ensure a tight connection. You
					will hear a “snap” when the connector is seated
					properly.
			5.		Push the battery cables and white cord as close
					to the battery tray as possible.
			6.		The battery pack is shipped with the front bezel
					removed (it is packaged separately within the
					main box).

Unpack the bezel and hold it with the cutout section on the right. Align the tabs on the side of the bezel with the slots on the front of the battery pack and gently snap it into place.

CONNECTING A BATTERY PACK TO THE SMART-UPS

Battery pack connectors are color-coded and keyed to prevent improper connec- tion. The color of the connector on the UPS must match the color of the battery pack connector.

Allow the battery pack to charge for 24 hours. Do not expect full run time during this initial charge period.

	1. Remove the rear connector plug from the
Œ	UPS Œ.

6