9
Configuration continued
Enabling remote control
By default, the management card does not allow commands issued from remote computers. To enable remote control, you must connect serially to the Silcon management card and change the default setting.
Connecting Serially through the Control Console.
1 | Connect | the supplied communication cable (APC part | |
| number | ||
| computer and to the Monitoring Port on front panel of | ||
| the chassis. |
| |
2 | Disable PowerChute | plus ,UNIX Respond, or other | |
service that may be using the serial port on the computer.
3Run a terminal emulator such as Windows™ HyperTerminal.
4Configure the appropriate serial port with the following
settings: 2400 | bps, no parity, | 8 data bits, | 1 stop bit, and |
no flow control. |
|
|
|
Note: Some terminal emulators such as HyperTerminal require that you disconnect and reconnect for the new serial settings to take effect.
5 From your computer, press | E NTER | until the user name |
prompt appears. |
|
|
6Enter the default user name and password: apc, both lowercase.
7From the Control Console, preform the following steps in the order given:
a | Choose |
| Device Manager | (number | 1 ) from the menu | ||
| and press |
| E NTER . |
|
|
| |
b | Choose the appropriate UPS from the menu and press |
|
| ||||
| E NTER . |
|
|
|
|
| |
c | Choose |
| Control | (number | 1 ) from the menu and press | ||
| E NTER . |
|
|
|
|
| |
d | Choose |
| Enable Remote Control |
| (number | 3 ) from the | |
| menu, press |
| E NTER ,and follow the prompts to enable | ||||
| remote control. |
|
|
|
| ||
e | Press | E SC until the Main menu appears. |
|
| |||
f | Choose |
| Logout | (number | 4) from the menu and press | ||
E NTER .
Note: The new settings will not take effect until you log out.
