American Power Conversion S20BLK Quick Configuration

B-3

Reference Documents

The APC Network Management Card utility CD contains the following

documentation:

• Network Management Card User’s Guide

• PowerNet MIB Reference Guide

• CD-ROM contents file (.\Contents\contents.htm)

• Network Management Card Release Notes

• Troubleshooting documents

Quick Configuration

This section covers NMC configuration, setup, and operating requirements.

Device IP Configuration Wizard

The APC Device IP Configuration Wizard configures the IP address, subnet mask,

and default gateway of Network Management Cards (NMCs), or APC network-

enabled devices (devices that contain an embedded Management Card). The Wizard

can be used in either of the following ways:

• Through a direct connection from a serial port on your computer to a Management

Card or device to configure or reconfigure it.

•Remotely over your TCP/IP network to discover and configure unconfigured

Management Cards or network-enabled devices located on the same network

segment as the computer that is running the Wizard.

Figure B2. Rear Panel I/O Communications Connectors

EthernetRS-232

USB

TEL/DVR/SAT/DSL

COAX IN/OUT

Contents

Main Page Safety Information Safety Information (Continued) iii Registration Verification Confirmation ! Protect Your Investment Safety Symbols Warnings, Cautions and Notes Warnings Cautions Notes ! Table of Contents Page Introduction Proven Expertise Proven Reliability Package Contents Safety Precautions Unit Power Capacity Features Communications and Management Universal Serial Bus RS-232 Network Management Card Environmental Monitoring Pure Sine Wave Battery Backup Automatic Voltage Regulation Surge Protection Front and Rear Panel Descriptions Page Page Page Rear Panel Controls and Connectors Page ! Page Installation Removing the Battery Pack Installing the Unit Installing the Unit on a Flat Surface Rack Mounting the Unit Inserting and Connecting the Battery Page Powering On and Connecting Equipment Performing the System Test APC - LEGENDARY RELIABILITY S20 POWR CONDITIONER WITH BATTERY BACKUP Page Page Status and Informational Screens Status Screens INPUT VOLTAGE: XXXV; OUTPUT VOLTAGE: XXXV SYSTEM LOAD: <XXXW; LOAD: <XXX% INPUT VOLTAGE: 124V OUTPUT VOLTAGE: 125V Informational Screens EST.RUNTIME: 2HRS FUEL: 100% SOURCE: UTILITY EST.RUNTIME: 2HRS Page Page Outlet Status Screens Connecting the Components DIGITAL OUTLETS:ON VIDEO OUTLETS:ON ANALOG OUTLETS:ON HI AMP OUTLETS:ON 2-13 S20BLK Setup AUDIBLE ALARM: ON SENSITIVITY:HIGH Page OUTPUT DELAY1: 5 SEC LOWBATWARNING:2MIN BATREPDATE:10-10-06 Page Page Troubleshooting Connected equipment reboots or turns off during or after the unit is on battery power REPLACE BATTERY LED is illuminated Contact Information General Information Technical Support Limited Warranty Specifications A Technical Specifications FCC Compliance Information S20BLK External Battery Pack (SBATT & SBATTBLK) Input: Output: Battery Backup: Communication Surge Protection: Physical: Page Network Card B NMC Major Features Integrated Environmental Monitor Reference Documents Quick Configuration Device IP Configuration Wizard Local (Serial) Access ARP and Telnet Access Control Console BOOTP How to Access the NMC Web Interface Teln et SNMP Page APC Worldwide Customer Support 10/2006 990-2974A