2 INSTALL
Push Tail piece (11) down into Trap (C) (threaded end up).
Thread Locknut (5), Washer (4) and Gasket (3) (Bevel side up) onto Drain Body (10).
Apply a bead of Putty (D) to underside of Flange (2).
Feed Drain Body (10) up through Sink (A) and thread the Flange (2) or (2A) fully onto Drain Body (10).
Tighten Locknut (5) firmly, keeping the pivot rod hole pointed towards the back of the sink.
Assemble Pivot Rod (9) as shown in
Insert Pivot Rod (9) into Drain Body (10) and tighten Pivot Nut (F).
Push TAILPIECE INSERT (12) into TAILPIECE (11) and push TAILPIECE up and thread tightly into DRAIN BODY (10).
Position Extension Rod (7) onto
1
2
A
3
4
5
10
D
E
6
7 7
F8
Remove one end of Clip (8) from Pivot Rod (9) by squeezing ends together while sliding.
12
11
C
9
Insert Pivot Rod (9) or (9A) into second or third hole in Extension Rod (7) and reassemble Clip (8).
Drop Stopper (1) into Drain Body (10).
Adjust stopper height by repositioning Extension Rod (7) and tightening Thumbscrew (6).
3 WATER SUPPLY CONNECTIONS
Note: FLEXIBLE HOSES (1, 2) on FAUCET (3) are
Important: If SUPPLY HOSES (1, 2) are to long, loop as illustrated to avoid kinking .
Connection on FLEXIBLE HOSES (1, 2) are 3/8" compression. Connect LEFT SUPPLY (1) to Hot shut off valve and RIGHT SUPPLY (2) to Cold shut off valve.
Use adjustable wrenches to tighten connections. Do not over tighten.
3
9 |
|
G | F |
1
COLD2
3/8" compression
HOT | SHUT OFF | |
VALVE | ||
|
M 9 6 8 2 9 0 A