SECTION 14—SCOOTER ACCESSORIES

INSTALLING/REMOVING THE REAR MOUNTED BASKET

NOTE: For this procedure, refer to FIGURE 14.6.

WARNING

The rear mounted basket is rated for a maximum capacity of ten (10) lbs.

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely.

The installation of the basket and basket bracket onto the back of the scooter seat increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to surrounding property may occur.

INSTALLING

1.If necessary, loosen but do not remove the mounting knob.

2.Install the basket bracket into the accessory tube.

3.Thread the mounting knob into the welded nut on the accessory tube. Securely tighten.

4.Align the mounting clips on the bracket with the slots on the basket and slide the basket DOWN securely into position.

REMOVING

1.Remove the basket from the bracket.

2.Loosen the mounting knob.

3.Remove the basket bracket from the accessory tube.

4.Tighten the mounting knob.

Mounting

Seat

Knob

 

Rear Basket

Accessory Tube

Slots

Mounting Clips

Basket Bracket

FIGURE 14.6 - INSTALLING/REMOVING THE REAR MOUNTED BASKET

300 and 400

68

Part No. 1118395

Page 68
Image 68
Invacare HMV Highly 300, HMV Highly 400 manual INSTALLING/REMOVING the Rear Mounted Basket