SECTION 12—BATTERIES
7.Connect the RED and BLACK battery connector to the wiring harness assembly. Tighten securely.
8.Secure batteries in the battery tray using the battery strap (Detail “A” of FIGURE 12.2).
9.Reinstall the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
10.Reinstall the seat. Refer to Removing/Installing the Seat on page 34.
NOTE: New batteries MUST be fully charged BEFORE using, otherwise the life of the batteries will be reduced.
11. If necessary, charge the batteries. Refer to Charging the Batteries on page 58.
DETAIL “A” - REMOVING/INSTALLING THE BATTERIES
Batteries
Batteries BatteryBattery Tray Removed
Installed Strap
Battery
Tray
NOTE: Seat and Rear Shroud not shown for clarity.
DETAIL “B” - BATTERY WIRING HARNESS
RED and BLACK
Battery Connector
50Amp Fuse |
|
|
|
POSITIVE (+) RED | RIGHT | LEFT | WHITE Battery |
Battery Cable | BATTERY | BATTERY | Cable (Jumper) |
|
|
| NEGATIVE |
|
|
| Battery Cable |
POSITIVE (+) RED |
|
|
|
Battery Terminal |
|
| NEGATIVE |
|
|
| Battery Terminal |
NEGATIVE |
|
| POSITIVE (+) RED |
Battery Terminal |
|
| Battery Terminal |
FIGURE 12.2 - REMOVING/INSTALLING THE BATTERIES ON 300
300 and 400 | 52 | Part No. 1118395 |
