SECTION 14—SCOOTER ACCESSORIES
INSTALLING/REMOVING THE CRUTCH/CANE HOLDER
NOTE: The Crutch/Cane Holder, Safety Flag and Oxygen Holder all install into the accessory tube; ONLY one (1) of these may be installed at a time.
WARNING
The installation of the crutch/cane holder onto the back of the scooter seat signifi- cantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 14.2.
INSTALLING
1.Install the crutch/cane holder into the accessory tube located on the back of the seat.
2.Install the mounting knob to secure the crutch/cane holder in place. Securely tighten.
3.Align the slot on the base with the hook on the crutch/cane holder and slide base DOWN into position.
REMOVING
1.Remove the crutch/cane holder from the accessory tube.
2.Remove the mounting knob that secures the crutch/cane holder in place.
3.Remove the crutch/cane holder from the accessory tube.
Crutch Cane | Mounting Knob |
| |
Holder |
|
Seat
Hook 
Accessory Tube
Base
FIGURE 14.2 - INSTALLING/REMOVING THE CRUTCH/CANE HOLDER
Part No. 1118395 | 65 | 300 and 400 |
