SECTION
REPLACING THE FUSE
WARNING
NEVER defeat or bypass any fuse. ONLY replace with a fuse of the same rating.
NOTE: For this procedure, refer to FIGURE 6.5.
1.Remove seat. Refer to Removing/Installing the Seat on page 34.
2.Remove rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
NOTE: Two (2) fuse holders are located on the wiring harness.
NOTE: Replace existing blown fuse with a new fuse of the same rating.
3.Pull fuse OUT and install new fuse.
4.Reverse STEPS 1 and 2 to reassemble the powered scooter.
Fuse
Fuse Holder
FIGURE 6.5 - REPLACING THE FUSE
Part No. 1118395 | 33 | 300 and 400 |
