SECTION 6—OPERATION OF THE POWERED SCOOTER
300 and 400 28 Part No. 1118395
FIGURE 6.1 - CONTROL PANEL3. CHARGING INDICATOR - Located on the TOP face of the control panel as shown in FIGURE 6.1. Solid RED indicates the charger is on (plugged into wall receptacle).4. STATUS INDICATOR - Located on the TOP face of the control panel as shown in FIGURE 6.1. Status LED will flash intermittently, separated by a pause, to provide diagnostic information. Refer to the following table.NUMBER OF FLASHES FAULT IMPACT ON SCOOTER NOTES1 Battery needs
recharging.
Will Drive Battery charge is running low. Recharge the
batteries as soon as possible.
2 Battery voltage
too low.
Drive Inhibited Battery charge is empty. Recharge the batter-
ies. If the scooter is left off for a few minutes,
battery charge may recover sufficiently to
allow driving for a short period of time.
3 Battery voltage
too high.
Drive Inhibited Battery charge is too high. Scooter will charge
batteries when traveling down slopes or
decelerating. Excessive charging in this man-
ner may cause this fault. Turn the scooter
power off and then back on again.
4 Current limit
time-out.
Drive Inhibited The scooter has drawn too much current for
too long, possibly because the motor has
been over-worked, jammed or stalled. Turn
the scooter power off and then turn back on
again after a few minutes.
5 Brake fault. Drive Inhibited Check that the brake release lever is in the
engaged position. The park brake coil or wir-
ing is faulty. Check the park brake and wiring
for open or short circuit.
BATTERY LEVEL
STATUS CHARGING
OFF
ON
On/Off Key
Switch
Horn Speed
Control Knob
Charging
Indicator LED
Battery Charge
Indicator LED
Status
Indicator LED On/Off Key
Switch
Horn Speed
Control Knob
Charging
Indicator LED
Battery Charge
Indicator LED
Status
Indicator LED
Headlight
Switch
DETAIL “A” - 300 DETAIL “B” - 400