American Standard 2171 Test Installed Faucet and Check for Leaks, 4a Check Drain Connections

4 TEST INSTALLED FAUCET AND CHECK FOR LEAKS

With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate HANDLE (1) to flush water lines thoroughly.

Replace AERATOR (3).

4a CHECK DRAIN CONNECTIONS

Operate LIFT ROD (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in lavatory. If necessary adjust stopper height by repositioning LIFT ROD (4) and tightening Thumbscrew (6).

Release DRAIN STOPPER (5) and check all drain connections and "P" trap for leaks. Tighten if necessary.

1

3

4

6

5

"P" TRAP

COLD

2

HOT

5 ADJUST HOT LIMIT STOP

By restricting HANDLE rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP (5) reduces risk of accidental scalding. To set the maximum hot water temperature of your faucet, all you need to do is adjust the setting on the HOT LIMIT SAFETY STOP (5).

Remove PLUG BUTTON (1). Loosen HANDLE SCREW (2) and pull off HANDLE (3).

Pull off CARTRIDGE CAP (4).

Use a flat blade screwdriver or your fingers to pull up and rotate red HOT LIMIT SAFETY STOP (5). Follow Step "A" or "B" to adjust min./max. discharge temperature. "0" being the hottest to "7" the coldest temperature setting. Factory set at "0".

Replace CARTRIDGE CAP (4) and HANDLE (3). Tighten HANDLE SCREW (2). Replace PLUG BUTTON (1).

3

1

4

2

"A"

PRY RED RING FORWARD AND ROTATE COUNTER- CLOCKWISE ONE CLICK

TEMPERATURE

SETTING NUMBERS

"B"

PRY RED RING FORWARD

"A"

					"A"
				0	ADJUSTMENT WHEN
			1
4		2			WATER IS TOO HOT
	3
5
6					6
7

AND ROTATE CLOCKWISE

"B"

ADJUSTMENT WHEN WATER IS TOO COLD

"B"

5

"RED RING"- HOT LIMIT SAFETY STOP

M 9 6 8 2 9 1 C