7 ATTACH CABLE CONNECTOR
Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. A.
Your new
Note: Tailpeice on
Fig. B.
Fig. A.
1
2
Fig. B.
8 CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.
Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.
1
2
9 MAKE WATER SUPPLY AND WASTE CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR
PURCHASED SEPARATELY.
Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE
SUPPLIES (2) or 3/8" O.D.
Use adjustable wrench to tighten connections. Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
Connect
1/2" PIPE | 1 |
THREAD |
|
2 | COUPLING |
NUT | |
FLEXIBLE |
|
SUPPLIES |
|
3
3/8 O.D.
RISERS
3/8” COMPRESSION CONNECTION
COMPRESSION NUT
FERRULE
HOTCOLD
M968881
3